User Manual

Date : 23 February 2012 Version 5
This information is furnished for guidance, and with no guarantee as to its accuracy or completeness; its publication conveys no licence under any patent or other right,
nor does the publisher assume liability for any consequence of its use; specifications and availability of goods mentioned in it are subject to change without notice; it is
not to be reproduced in any way, in whole or in part, without the written consent of the publisher.
© Nedap N.V., IDEAS P.O. Box 103 NL-7140 AC GROENLO The Netherlands
Page 1 of 4
Part.no.: 5265800
Invexs 170 readers
Mifare Nedap dual technology readers
GENERAL
The Invexs 170 reader series is capable of reading
(simultaneously) Nedap, Mifare and DESFire credentials due to
its dual reader technology. The Invexs can read Mifare,
DESFire and Nedap cards, and is equipped with keypad and /
or a display.
The Invexs output can be set to either Wiegand, XS RF
modulation or RS485 protocol (plain or encrypted)
Functionality and output are determined by the configuration of
the Invexs reader. The configuration is defined using the
programm AEreco, and deployed by the configuration card or
via AEmon. (More information about configurations can be
found in ConvexsInvexs_InstallGuide_E.)
Three LED’s (red, green, blue) and beeper are included (display version has no LED). Ciphers of the
keypad versions light up after activation, so when not active the ciphers are not visible.
Back panel is available in two colours, black and white (e.g. MNK170B, MNK170W)
DIMENSIONS
MOUNTING PROCEDURE INVEXS
For mounting the Invexs, the back plane must be placed on the wall first.
For removing the back plane from the Invexs, unscrew the two screws (1) at
the bottom of the Invexs and push the front cover up (2). Mount the back
plane using the 4 holes.
Connections must be made on the connector on the backside of the front.
After making the connections, replace the front and tighten up the two screws
at the bottom of the Invexs.
®
Installation sheet
75.2
52
40
6.8
4.8
20.3
120 8
40
170.5
24.5
1.5
0.5
Dimensions: 171 x 75 x 25 mm.
4 mounting holes available at 52 x
120 mm
Cable outlet: 40 x 40 mm
1
2
3
4
5
6
7
8
9
C
0
E
Un screw
Push up
1
2
1
2
3
4
5
6
7
8
9
C
0
E
1
2
3
4
5
6
7
8
9
C
0
E