Installation Guide

www.nedap-luxon.com

EN–US

Language

Luxon Bridge

p/n 9986294

Installation guide

1. Before you start,

check the package contents

 Luxon Bridge

 DIN-rail clips (2x)

 Blind plug for cable gland (2x)

 Installation guide

Installation of electrical components must

be completed by a certified electrician as per

local codes and regulations.

2. Mounting

1. Mount the Luxon Bridge to a wall or other flat mounting surface

using pan-head screws, max 4.5mm diameter.

2. Alternatively, in case of DIN-rail mounting, click the DIN-rail clips

into the rear of the Luxon Bridge.

3. Wiring

Connect the Luxon Bridge to mains power.

(100-347Vac 50/60Hz)

Make sure the mains power source is not powered

during installation.

Connect the required sensor or switch to an I/O port.

PAGE 1
EN–US Language Luxon Bridge Installation guide 1. Before you start, check the package contents     Luxon Bridge DIN-rail clips (2x) Blind plug for cable gland (2x) Installation guide Installation of electrical components must be completed by a certified electrician as per local codes and regulations. 2. Mounting 1. Mount the Luxon Bridge to a wall or other flat mounting surface using pan-head screws, max 4.5mm diameter. 2.
PAGE 2
1. 2. 3. 4. 5. 6. 7. 8. 4. Open the wiring compartment after loosening the two screws on the front. Enter the mains cable through the left wire gland. Connect L and N wire to corresponding terminals, no earth connection required. If applicable, connect the switched mains line to the Sensor input. Enter the sensor and/or switch cable using the smaller two cable glands. Connect the wires to the correct I/O terminals, see section 5 for details. Mount the wiring compartment cover.
PAGE 3
6. FCC and ISED declarations Compliance statement (part 15.19) This device complies with part 15 of the FCC Rules and to RSS of ISED. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Déclaration Conformité Cet appareil se conforme aux normes RSS exemptés de license du ISED.