Aterm MR03LN Instruction Manual
Contents Contents ........................................................................................ 2 Important Product Information ....................................................... 3 Safety Instructions ......................................................................... 4 Notice ............................................................................................ 8 1. Package Contents ................................................................. 11 3.
Important Product Information Important safety information regarding radio frequency (RF) exposure and use when worn The product “MR03LN”is declared to conform with the essential requirements of European Union Directive 1999/5/EC Radio and Telecommunications Terminal Equipment Directive 3.1(a), 3.1(b) and 3.2. This wireless portable device complies with the EU requirements for exposure to radio waves. Your wireless portable device is a radio transceiver and receiver.
Safety Instructions Please read these Safety Instructions carefully before using this product. These Safety Instructions show items that must be followed to prevent danger to any person and damage to property. Alert symbols below are important to fully understand these Safety Instructions. Alert symbols in this instruction manual Warning : Indicates a hazardous situation which could result in death or serious injury.
Warning ●Do not attach the battery pack forcibly if you are having trouble attaching it. When attaching the battery pack, check the direction of the battery pack. Ignition, explosion, overheating or leakage of the battery pack may result. ●Do not throw the battery pack into fire. Ignition, explosion, overheating or leakage of the battery pack may result. ●Do not pierce the battery pack with a nail, hit it with a hammer or step on it.
Warning In these cases ●Do not dispose of old batteries with ordinary household waste. Ignition or environmental damage may result. Cover the battery terminals with a non-conductive tape and dispose of them in accordance with local waste disposal regulations. ●Do not use or charge a wet battery pack. Ignition, explosion, overheating or leakage of the battery pack may result. ●If the liquid inside the battery pack leaks out, keep the liquid away from your skin such as face or hands.
Warning Other warnings ●Turn off this product in any place where use of a wireless device is prohibited, for example in an airplane or hospital. Otherwise, it may influence electronics and medical devices, and cause an incident. ●Do not place or use this product near high-precision electronics or devices which handle weak signals, for example pacemakers. Otherwise, electronics such as pacemakers may malfunction.
Notice Indicates a situation which could result in this product performing poorly or malfunctioning. What you must not do ●Do not drop or hit this product. Otherwise, it may malfunction. ● Do not leave this product in a cold place such as an ice warehouse. Otherwise, this product may operate abnormally. ●Disconnect all cords before moving this product. Otherwise, it may malfunction.
Other warnings ● If you turn off or disconnect this product during data communication, communication may fail or data may be damaged. If your data are important, check them against the original. Notes on wireless LAN ●The standard values of wireless LAN are the maximum theoretical values when communication is carried out with other products with the same configuration as this product. The standard values may not indicate the actual data transfer rate.
Security notes on wireless LAN products Wireless LAN has the advantage of a LAN connection without the use of LAN cables if the device is placed within the reach of radio waves. You can send and receive information between devices that use radio waves such as a computer and the wireless LAN access point (base unit).
1. Package Contents This product package contains the following items.
3.
Product label Look at the product label on the left side of this product *The label is an example. to configure a wireless LAN terminal [client].
4. Using microSIM A microSIM is an IC Card that stores personal information such as your phone number. Without the microSIM installed in this terminal, you cannotuse data communication. For details on handling the microSIM,refer to the microSIM manual. When inseting and removing the microSIM,hold this terminal with both hands. Inseting the microSIM (1) With the IC chip side down, insert a microSIM under the microSIM slot in the direction of arrow.
5. Attaching and Detaching the Battery Pack When attaching and detaching the battery pack, hold this terminal with both hands. Attaching the Battery Pack (1) With the “ ”side of the battery pack up, align the metal contacts of both the Battery pack and terminal, attach the battery pack in the direction,and then Push it down in the direction. Battery contacts (2) Check the direction of the Battery cover and attach it to the terminal.
6. Network Setup 2G 2G Wireless LAN Registering the Access Point Setting (1) In the top menu, click ”基本設定”. (2) In the submenu, click “接続先設定(2G/3G)” (3) Click “高度な設定を表示” (4) “国際ローミング”, put a tick “使用する” (5) Click “編集” (6) On the setting screen, set the required items. 接続先名, 接続サービス, APN, ユーザー名, パスワード, 暗号化方式, 接続方式 (7) To register a new access point, click “設定” Connecting to Windows PC For Windows7 (1) Turn on the wireless LAN function of a PC.
7. Web Setting (1) Start the PC and others. (2) Start a WWW browser, enter "http://192.168.179.1/" and open the page for Web configurations. (3) Enter the user name and password. The user name is "admin" and the password is "1234" (default value). (4) The "管理者パスワード変更" screen appears. Change the administrator's password as you like, and write it down in the "Administrator's password" box below. Do not forget to write down your administrator's password.
(5) Select the menu you want to modify, and proceed.
8. Products Specifications Item Antenna HSPA WAN GSM850 EGSM900 DCS1800 PCS1900 Antenna IEEE802.11b Wireless LAN IEEE802.11g IEEE802.11n USB port Physical interface Port Type Condition Antenna built in UL:1920-1980MHz,DL:2110-2170MHz Frequency Band1 Frequency UL:824-849MHz, DL:869-894MHz Frequency UL:880-915MHz, DL:925-960MHz Frequency UL:1710-1785MHz, DL:1805-1880MHz Frequency UL:1850-1910MHz, DL:1930-1990MHz Antenna built in Frequency 2.4GHz (2412-2472MHz)/1-13ch band/CH Bit rate 1/2/5.
Notice (1) All rights reserved. No part of this manual may be copied or reproduced without prior permission. (2) Contents of this manual may change without notice. (3) We take every possible precaution to ensure the accuracy of this manual, but if anything is unclear or erroneous in the content, please contact us. (http://www.necat.co.
Europe – EU Declaration of Conformity This device complies with the essential requirements of the R&TTE Directive 1999/5/EC.
Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Radiation Exposure Statement The product comply with the FCC portable RF exposure limit set forth for an uncontrolled environment and are safe for intended operation as described in this manual. The further RF exposure reduction can be achieved if the product can be kept as far as possible from the user body or set the device to lower output power if such function is available.
NEC AccessTechnica, Ltd. Aterm MR03LN Instruction Manual 1st Edition 9.