NebuLink Node NLN 100C Datasheet System Level Solutions, Inc. (USA) 511 N. Washington Avenue Marshall, Texas 75670. (408) 852 - 0067 http://www.slscorp.com Node Version: 1A Document Version: 1.
Copyright ©2019, System Level Solutions, Inc. (SLS) All rights reserved. SLS, an Embedded systems company, the stylized SLS logo, specific device designations, and all other words and logos that are identified as trademarks and/or service marks are, unless noted otherwise, the trademarks and service marks of SLS in India and other countries. All other products or service names are the property of their respective holders. SLS products are protected under numerous U.S.
About this Manual Revision History Table below shows the revision history of NebuLink Node NLN 100C’s datasheet. Version How to Contact SLS Date Description 1.2 November 2019 Added note in Table 1-1 1.1 April 2019 Added Figure 1.1 and Chapter 4 Updated Table 1.1 in Chapter 1 1.0 July 2018 First publication For the most up-to-date information about SLS products, go to the SLS worldwide website at http://www.slscorp.com.
Typographic Conventions Visual Cue This datasheet uses the typographic conventions as shown below: Meaning Bold Type with Initial Capital letters All headings and Sub headings Titles in a document are displayed in bold type with initial capital letters; Example: General Description, Features. Bold Type with Italic Letters All Definitions, Figure and Table Headings are displayed in Italics. Examples: Figure 1-1. NebuLink Node NLN 100C, Table 1-1. NebuLink Node NLN 100C Specifications. 1., 2.
Contents About this Manual.............................................................................................................. iii Revision History ......................................................................................................................................iii How to Contact SLS ................................................................................................................................iii Typographic Conventions ........................................
1. Overview General Description The NebuLink Node NLN 100C provides a means for any electronic device to implement low cost wireless connectivity. This Node inter operates with either Zigbee or 6LoWPAN devices depending on the programmed stack. NLN 100C is ideal for applications in the energy and controls markets where manufacturing efficiencies are critical. The NLN 100C, built around the NXP JN5169 SoC (system on a chip) radio IC, integrates an 802.15.
Benefits NLN 100C-2 NLN 100C-3 Benefits The main benefits of the NebuLink Node NLN 100C are: Customizable Zigbee and 6LoWPAN applications with a programmable CPU A rich set of hardware peripherals such as GPIO, UART, SPI, I2C, ADC, and PWM A great choice for battery oriented applications with various sleep modes 2 NebuLink Node NLN 100C Datasheet • Sleep with IO wake up • RAM Retention • Low Power mode System Level Solutions November 2019
Overview • Deep Sleep mode Comes in three variants based on Antenna type • U.FL Connector (NLN 100C-1) for External Antenna • PCB Antenna (NLN 100C-2) • PCB Antenna or U.FL Antenna (NLN 100C-3) Provides an OTA (Over the Air) Firmware update mechanism Supports Mesh networking for both Zigbee and 6LoWPAN Supports deployment of a dense network with 6LoWPAN Figure 1-2. shows the NebuLink Node NLN 100C. Figure 1-2.
Benefits Figure 1-3. shows NebuLink Node NLN 100C application example. Figure 1-3.
Overview Specifications Table 1-1. describes specifications of the NebuLink Node NLN 100C. Table 1-1. NebuLink Node NLN 100C Specifications Performance Data Rate Up to 250Kbps Range* 80 Meters Line of Sight (LoS) with Antenna 2dBi Gain TX Current Consumption 26.8mA@ +10dBm; 19.6mA@ +8.5dBm; 14mA @ +3dBm RX Current Consumption 19.
Node Accessories Table 1-1. NebuLink Node NLN 100C Specifications Networking and Security Protocol 6LoWPAN, Zigbee, Thread, 802.15.4 Proprietary Encryption AES 128 Bit Channels 16 Note: * Tested in standard laboratory conditions # Ideal temperature condition based on component’s rating Node Accessories NLN 100C comes with an external antenna. Table 1-2. provide the details of the external antenna. Table 1-2.
2. Pin-Out Information Table 2-1. shows the NebuLink Node NLN 100C Pin-Out. Table 2-1.
Table 2-1.
Pin-Out Information Table 2-1.
3. Package Information Figure 3-1. shows physical dimensions of all variants of NebuLink Node NLN 100C. Figure 3-1.
Package Information System Level Solutions November 2019 11 NebuLink Node NLN 100C Datasheet
4. Test Report Figure 4-1. and Figure 4-2. shows the test result of NebuLink Node NLN 100C measured in a RF lab under standard conditions. Figure 4-1.
Test Report Figure 4-2.
NLN 100C-2 NLN 100C-3 14 NebuLink Node NLN 100C Datasheet System Level Solutions November 2019
(OEM) Integrator has to assure compliance of the entire end-product incl. the integrated RF Module. For 15 B (§15.107 and if applicable §15.107) compliance, the host manufacturer is required to show compliance with 15 while the module is installed and operating. Furthermore the module should be transmitting and the evaluation should confirm that the module's intentional emissions (15C) are compliant (fundamental / out-of-band). Finally the integrator has to apply the appropriate equipment authorization (e.
Module statement The single-modular transmitter is a self-contained, physically delineated, component for which compliance can be demonstrated independent of the host operating conditions, and which complies with all eight requirements of § 15.212(a)(1) as summarized below. 1) The radio elements have the radio frequency circuitry shielded. 2) The module has buffered modulation/data inputs to ensure that the device will comply with Part 15 requirements with any type of input signal.
