User Manual

ManualsBrandsNCR Corporation, RSD - Atlanta ManualsElectronics2381 Gripper RFID

Table Of Contents

5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598

Certification Exhibit

FCC ID: JEH2381GRPR

IC: 470B-2381GRPR

FCC Rule Part: 15.225

IC Radio Standards Specification: RSS-210

ACS Report Number: 10-0326.W06.11.A

Manufacturer: NCR Corporation

Model: 2381GRPR

Manual

Summary of content (6 pages)

PAGE 1
Certification Exhibit FCC ID: JEH2381GRPR IC: 470B-2381GRPR FCC Rule Part: 15.225 IC Radio Standards Specification: RSS-210 ACS Report Number: 10-0326.W06.11.A Manufacturer: NCR Corporation Model: 2381GRPR Manual 5015 B.U.
PAGE 2
NCR SelfServ Entertainment 2381 Gripper RFID User Guide
PAGE 3
FCC Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
PAGE 4
Who Should Use This Document This user guide is intended for use by anyone seeking to operate the 2381 Gripper RFID reader independently from the 2381 DVD kiosk as a stand-alone RFID reader. Parts Identification The 2381 Gripper RFID module and unique USB cable is pictured below. Observe that the antenna is integrated into the center of the reader PCBA. A 3.3V/5V dual output power supply is required to power the reader.
PAGE 5
System Setup You will need: • PC or laptop running Windows XP • 3.3V/5V dual output power supply • Power supply cable • Microsoft .NET 3.5 • HID terminal software • 2381 FCC Test Firmware IMPORTANT: You must obtain and update the 2381 Gripper RFID board with FCC Test Firmware before using the reader in a stand-alone configuration. Refer to the 2381 Installation Guide for firmware update instructions. Connect the power cable (foreground) and power supply to the board.
PAGE 6
Operation Open a HID terminal session by selecting the NCR DVD Vending Kiosk HID Terminal icon from the desktop. Accept the default options and click on the Connect button. Then select rfid from the main menu. Figure 4 Select option 4, Gripper RFID Test, to initiate an ISO15693 inventory command, and then present an RFID tag to the RFID antenna. The reader will repeatedly send inventory commands until it is interrupted. The terminal will display the UID of any RFID tag that responds to the command.