User's Manual

ManualsBrandsNBS Payment Solutions ManualsElectronicsPoint of Sale Terminal

510H

Wireless Terminal

USER GUIDE

NBS Payment Solutions Inc.

Corporate Headquarters - Canada

703 Evans Avenue, Suite 400

Toronto, Ontario, M9C 5E9

Canada

Tel: +1 416 621-7410

Fax: +1 416 621-2450

510H User Guide

UNPACKING THE 510H

Carefully preserve the packaging of the terminal. It must

be re-used whenever the terminal is shipped.

Packaging contains:

• The terminal itself, equipped with its paper roll.

• Detachable power supply unit. (The power supply unit

delivered with your terminal is specially designed for

it. Do not use any other power supply.) The use of a

power supply having apparently similar

voltage/current characteristics may, in spite of this,

damage your terminal.

• Battery.

• Installation Guide.

SAFETY INSTRUCTIONS

To power down the 510H:

• Disconnect the power supply block from the

electric power supply network.

• Press and hold the key until the display

shuts off.

Electrical power supply network

Provide an A.C receptacle that meets the following

recommendations:

• Connector is installed near the equipment and is

easily accessible

CHARGING THE TERMINAL

Select an electrical socket that complies with the general

safety instructions as outlined in “Safety Instructions.”

Connecting the Power Supply to the Optional Base

• Insert the small

connecter on the

power supply cable

into the socket at the

back of the optional

charging base.

• To charge the

terminal, gently place

the terminal on to the charging base.

Connecting the Power Supply directly to the

510H

• Insert the small

connector on the

power supply cable

with the triangle

facing up, in to the

centre socket on the

back of the

510H terminal

• The terminal will

automatically power

on and start to

charge.

To decrease the charging time, the terminal may be

powered off by pressing the key until the display

shuts off.

Summary of content (2 pages)

PAGE 1
510H User Guide 510H Wireless Terminal UNPACKING THE 510H Carefully preserve the packaging of the terminal. It must be re-used whenever the terminal is shipped. USER GUIDE CHARGING THE TERMINAL Select an electrical socket that complies with the general safety instructions as outlined in “Safety Instructions.” Connecting the Power Supply to the Optional Base • Insert the small connecter on the power supply cable into the socket at the back of the optional charging base.
PAGE 2
INSTALLING A ROLL OF PAPER • • Depress the printer door release button (see arrow) to disengage the paper door from the terminal. Tilt the paper door towards the rear of the terminal. • Remove and discard the empty paper roll. • Verify that the roller is intact and securely attached to the paper door. • • • INSTALLING A SIM CARD The SIM card is located within the terminal. • Power off the terminal by pressing the key until the display shuts off.