2018 20180327 6U 9U 12U 15U 18U 22U
Packaging List 1. Top Panel 2. Bottom Panel 3. Frames 4. Front Door 5. Side Panels 1pc 1pc 2pcs 1pc 2pcs 6.Horizontal Beams 7.L Type Mounting Brackets 8. Back Panel 9.Mounting Bracket 10.Vertical Mounting Rails 1pc 1pc 2pcs 1pc 2pcs Item List Accessories Packaging Assembly Hardwares: A. M6*12 Screw 12PCS M6 Cage Nut 12PCS B. M6*12 Screw 12PCS(6U~12U) 24PCS(15U ~ 22U) M6 Cage Nut 12PCS(6U~12U) 24PCS(15U~22U) M6 Plastic Washer 12PCS(6U~12U) 24PCS(15U~22U) C.
Step 1 – Attach Bottom Panel to Front and Rear Frames Lay Bottom Panel (#2) on a hard surface. Be sure to protect it from scratching with cardboard or cloth. Insert Front and Rear Frames (#3) with large flange oriented to the inside.Be sure that the slots in the center of the frames are facing inward as shown below. Overlay the Horizontal Beams so that the notches interlay with the large flanges on the Front and Rear Frames. The holes for the hex nut and screw should align properly.
Step 3 – Install the Vertical Mounting Rails (#10) Install the Vertical Mounting Rails (#10) to the Horizontal Beams at the desired depth using the Cage Nut Kit provided (Bag A). When determining the appropriate depth, be sure to consider the equipment that you plan to mount inside the enclosure. (This may include the provided L Brackets). 6 6 5 5 4 4 3 3 2 2 1 1 Note: Be sure that the rail depth is the same on both sides of the cabinet.
Step 4 – Install L Type Mounting Brackets (Optional) Mount the provided L Type Mounting Brackets (#7) to the Vertical Mouting Rails on each side of the cabinet using the cage nut kits provided (Bag A) Page 5
Step 5 – Attach the Back Panel Attach the Back Panel (#8) to the assembly using the M4 Screws (Bag C) (6 pcs) provided.
Step 6 – Side Panels Click the Side Panels (#5) into place using the plastic tabs on either side.
Step 7 – Assemble the front lock and attach the Door Assemble the front door lock as shown in the picture below: To install the Tempered Glass Door (#4), locate the side with two pins. Insert the fixed pin into door hinge hole. With your thumb, pull down on the spring pin and slide it into place over second door hinge hole and release. The pin should click into place, securing the door.
Step 8 – Install Cable Management Covers (optional) Attach the top and Bottom Cable Management Panels using the M4 Screws (BagC 2 pcs each) provided.
Step 9 – Mounting Bracket M4 4 Bag Page 10
Step 10 – Install Casters - (Optional and only compatible and included with 15, 18 and 22U versions of the Performance Series Cabinets) Attach Casters(Bag F) with M6 screws (Bag G) to bottom of the cabinet.