User's Manual

Table Of Contents

National Electronics & Watch Co,. Ltd.

Bike Speed & Cadence Sensor Installation

How to install the Bike Speed & Cadence sensor

• Place the Speed sensor on the rear chain-stays. Loosely attach the sensor using two

cable ties.

Note: Place the rubber pad in between the Speed sensor and the Chain-stays for

stability.

• Attach the Spoke magnet to the spoke. The speed sensor must be within 5 to 10 mm.

of the spoke magnet.

• Place the Cadence sensor on the front chain-stays. Loosely attach the sensor using

two cable ties

Note: Place the rubber pad in between the Cadence sensor and the Chain-stays for

stability.

• Attach the Pedal magnet to the spoke. The Cadence sensor must be within 5 to 10

mm. of the spoke magnet.

-Working temperature: -10 deg. to +50 deg.

CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED BY

AN INCORRECT TYPE. DISPOSE OF USED BATTERIES

ACCORDING TO THE INSTRUCTIONS.

PAGE 1
National Electronics & Watch Co,. Ltd. Bike Speed & Cadence Sensor Installation How to install the Bike Speed & Cadence sensor • Place the Speed sensor on the rear chain-stays. Loosely attach the sensor using two cable ties. • Place the Cadence sensor on the front chain-stays. Loosely attach the sensor using two cable ties Note: Place the rubber pad in between the Cadence sensor and the Chain-stays for stability. • Attach the Pedal magnet to the spoke. The Cadence sensor must be within 5 to 10 mm.
PAGE 2
National Electronics & Watch Co,. Ltd. Hereby, National Electronics & Watch Co. Ltd declares that this device is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This device complies with Part 15 of the FCC Rules and with RSS-210 of Industry Canada.