User's Manual

ManualsBrandsNational Electronics & Watch ManualsElectronicsGPS Watch with 2.4G HRM

National Electronics & Watch Co,. Ltd.

BC04

M11-870 GPS watch User Manual

Ref: XT7 M11-870D sw01-022

Introduction

Thank you for purchasing the GPS watch. This GPS watch is packed with personal Training

features like speed, trip time, laps, etc. GPS navigation features were integrated in various

modes like Run mode and Waypoint mode. GPS can display your current location in an

electronic map. It has also a dedicated Altimeter sensor for altitude and atmospheric pressure

measurement. Watch features include 12/24H Time format, Chronograph, World time, 5 daily

Alarms, Data, and Set modes. This watch can communicate with a PC to store and review your

performance. This watch also has a power saving mode to increase operating hours. It uses a

rechargeable battery that can be charged through USB port of your PC. It also uses HRM belt

(optional unit) with 2.4 GHz technology to monitor your heart rate for all your HR related

information.

Caring for your GPS watch:

Clean your GPS watch and heart rate monitor with a dampened cloth preferably with mild

detergent solution. Wipe dry using a dry cloth. Do not use chemical cleaners and solvents that

may damage plastic components.

Do not store your GPS watch to prolonged exposure to extreme temperatures as this may result

to permanent damage to your unit.

About GPS:

Global Positioning System (GPS) is a satellite- based navigation system made up of a network

of 24 or more satellites. GPS works best in clear weather condition, anywhere in the world, 24

hours a day. Tall buildings may interfere with GPS accuracy. When 3 satellite signals are

received, the watch will have 2D GPS fixed (Latitude and Longitude). When 4 or more satellite

signals are received, the watch will have 3D GPS Fixed (Latitude, Longitude, and Altitude).

Water immersion:

This GPS watch is designed to be water resistant up to 3 ATM. It can resist water pressure up

to 30 meters. After submersion to water, please make sure to wipe dry and air dry the unit

before using or charging.

Caution: This unit is not intended to be used while swimming. Prolonged water submersion may

cause electronic shorting in the unit which may cause minor skin burn or irritation.

Getting Started

Step 1) Know your watch:

Push button location:

Push button Function:

S1 – Start / Lap / Increase adjust / Fast increase adjust

S3 – Stop / Save/ Decrease adjust / Fast decrease adjust

S5 – View / Confirm

S7 – Mode / Exit

S9 – GPS On / Hold to turn Off GPS

S11 – Light

Note: Actual color of the watch and artwork may vary from style to style.

Summary of content (15 pages)

PAGE 1
National Electronics & Watch Co,. Ltd. M11-870 GPS watch User Manual Ref: XT7 M11-870D sw01-022 Getting Started Introduction Thank you for purchasing the GPS watch. This GPS watch is packed with personal Training features like speed, trip time, laps, etc. GPS navigation features were integrated in various modes like Run mode and Waypoint mode. GPS can display your current location in an electronic map. It has also a dedicated Altimeter sensor for altitude and atmospheric pressure measurement.
PAGE 2
National Electronics & Watch Co,. Ltd. Power Saving Screen: This watch has a power saving feature to prolong battery life. When GPS is OFF, HRM is not linked, and no key operation for 1 minute, the display will auto go to Power saving screen. In power saving Screen, Press S7 to go to Run mode. Press any other key will go from power saving screen to Time mode. When the battery is low, it is time to charge the GPS watch. Note: You cannot turn ON the GPS when the battery is low.
PAGE 3
National Electronics & Watch Co,. Ltd. 4.4) If you press S9 again, the watch will momentarily display GPS / INDOOR. User can select GPS or INDOOR by pressing S1/S3. If you select GPS, it will display your current location, and then go to RUN mode. If you select INDOOR, the watch will go direct to RUN mode and you will have no GPS function. 4.
PAGE 4
National Electronics & Watch Co,. Ltd. 6.2.2) The watch will prompt you to select GPS or INDOOR. Press S1/S3 to select. If you select GPS, the watch will automatically search for GPS signal. If you select INDOOR, you will be performing your exercise without GPS signal. 6.2.3) After your selection, the watch will display the remaining BATTERY power level, remaining DATA TRACK MEMORY and then display view 1. Press S5 to change views. 6.2.4) Press S1 to START or TAKE LAP.
PAGE 5
National Electronics & Watch Co,. Ltd. 6.7.6) Press S5 to start your exercise (the chronograph will auto start). 6.7.7) Press S5 again to change views 6.7.8) Press S1 to START or TAKE LAP. If auto lap function is set, the watch will take lap automatically based on auto lap setting. 6.7.9) Press S3 to STOP after you complete your exercise. 6.7.10) Press and hold S3 to save your exercise. Note: If there is no GPS signal, RUN mode, or GO TO WAYPOINT function is running, you cannot use GO BACK function.
PAGE 6
National Electronics & Watch Co,. Ltd. • Select TIME 1 by pressing S5 • Select AUTO or MANUAL setting by pressing S1 or S3 and then press S5 to enter. AUTO setting: ¾ Select TIME ZONE by pressing S1/3 and then press S5/S7 to enter. There are 106 cities to select in this time zone setting. ¾ Select DST ON or OFF by pressing S1/S3 and then press S5/S7 to enter.
PAGE 7
National Electronics & Watch Co,. Ltd. If the power level of the battery is low, the GPS cannot be turned on. The watch will display BATT.LOW. HRM Æ RUN/ GPS ON / GPS OFF Æ LOCATING SATELLITES Æ BATTERY level Æ DATA TRACK MEMORY Æ view 1 of ALTI mode If the power level of the battery is low, the GPS cannot be turned on. The watch will display BATT.LOW after the screen GPS OFF. Different views in HRM mode: Following are the various views that User can choose by pressing S5 in HRM mode.
PAGE 8
National Electronics & Watch Co,. Ltd. 07 04 1 02 G - Month - Day - Data is referred to Time 1 or 2 for Time 2 - File number of the day - Data with track from GPS (if replaced with H- data w/o track, w/o GPS) Data mode Sub-modes If there is no GPS signal, or the Run mode is running, you cannot use the GO BACK or GOTO function.
PAGE 9
National Electronics & Watch Co,. Ltd. Going to your saved WAYPOINT At Waypoint Mode, Press S1 / S3 to select a desired Waypoint. Press S5 to choose a waypoint. After pressing S5 you will be prompted with GOTO / EDIT / DELETE options. Press S1 / S3 to scroll thru these options. Press S5 to confirm. If there is no GPS signal, the user cannot use the GOTO waypoint function. Choose GOTO to start your exercise. You will be going from your current location to the coordinates of the selected Waypoint.
PAGE 10
National Electronics & Watch Co,. Ltd. Press S5 to enter the time sub mode. In these sub modes, you can set the TIME 1, TIME 2, Time zone, etc. Press S1/S3 to scroll through these sub modes. To set the Auto lap: 1. Press S5 to set the Auto lap. 2. Press S1/S3 to select the various settings. Following are the auto lap preset range: OFF, 0.5 Km, 1 Km, 2 Km, 3 Km, 4 km and 5 Km. Default value is 1.0 KM. 3. Press S5/S7 to save the selection and exit.
PAGE 11
National Electronics & Watch Co,. Ltd. HRM LINK setting: Press S5 to start linking your HRM belt. The watch will display the old HRM ID and then start searching for new HRM ID. If a new belt ID is found, it will display new the ID and then prompt the user to use the new ID (YES or NO). If you select NO by pressing S1/S3, it will use the OLD ID and go to RUN mode. 1. 2. 3. Press S5 to enter Key tone setting. Press S1/S3 to turn ON or OFF Press S5 to accept and exit.
PAGE 12
National Electronics & Watch Co,. Ltd. GPS watch troubleshooting guide: PROBLEM/ QUESTION I cannot get a GPS signal Can I reset the watch? Will my data and personal settings be lost after watch reset? The battery indicator does not seem to be accurate My heart rate data seems inaccurate. SOLUTION/ ANSWER Take your GPS watch outdoors and away from tress and tall buildings. Remain stationary and try acquiring GPS signal again.
PAGE 13
National Electronics & Watch Co,. Ltd.
PAGE 14
National Electronics & Watch Co,. Ltd. GPS NE PRO PC software Your GPS watch comes with PC software. This software is compatible with the following operating system: • • • • • Windows 7 Windows XP SP 1, 2, 3 Windows Vista SP 1, 2 Windows 2000 SP 4 Windows 98 6) After downloading the data, the software will prompt you to delete all data in the GPS watch. Default option is NO. WARNING! If you select yes, all data in the watch will be deleted. You can use the software to view and analyze your data.
PAGE 15
National Electronics & Watch Co,. Ltd. FCC Statement 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.