User Manual

Model No: M10-843

Model: 2.4GHz Digital Chest Strap

Features:

The 2.4GHz digital chest strap is designed to pick up heart rate signal from the skin of

the chest and converted into digital data. The digital data is transmitted out by 2.4GHz

RF signal. Receiver with 2.4GHz receiver can pick up the digital data and displayed

on the screen or display.

How to Use the 2.4GHz Digital Heart Rate Belt:

Wear the Heart Rate Belt on your chest with the sensor over your heart for detection

of the heart rate.

1. You will notice that there are two long grooved oval patches on the inside of the

heart rate belt. These are the electrode sensors for detecting your heart rate. Before

you put on the heart rate belt, wet these patches lightly with water or a conductive gel

using your index finger so that the sensors can better detect your heart rate.

2. Open up the belt by unbuckling one of the side clasps that connects the fabric strap

to the plastic strap.

3. Wrap the heart rate chest belt across your chest. Adjust the tightness of the strap

so that the strap sits snugly and comfortably just below your pectoral muscle. Close

the clasp.

4. Check that the wet electrode areas are firmly pressed against your skin and that the

logo is in a central upright position.

5. Turn on the Heart Rate Receiver by pushing button and entering the heart rate

mode. If a heart rate is detected by the receiver unit, the heart symbol should flash on

the receiver display, and your beats per minutes should be displayed on the screen.

Trouble Shooting:

• If you don’t get your heart rate within 15 seconds when using the Sensor Ring,

moisten finger pads and try again. It helps to wear the chest strap for a little while to

allow a layer of moisture to build up between the electrodes and your skin.

• If you don’t get a continuous readout when using the chest strap, check that strap is

properly positioned and fastened.

PAGE 1
Model No: M10-843 Model: 2.4GHz Digital Chest Strap Features: The 2.4GHz digital chest strap is designed to pick up heart rate signal from the skin of the chest and converted into digital data. The digital data is transmitted out by 2.4GHz RF signal. Receiver with 2.4GHz receiver can pick up the digital data and displayed on the screen or display. How to Use the 2.4GHz Digital Heart Rate Belt: Wear the Heart Rate Belt on your chest with the sensor over your heart for detection of the heart rate. 1.
PAGE 2
• Body hair or a thin layer of body grease may also interfere with the signal: if you wish to remove body grease, wipe chest and back of chest strap with tissue or soft cloth. • Exercising vigorously with a lot of body movement or body motion can cause “muscle noise” that may prevent chest strap from detecting a HR signal. • In dry or hot climates, you may need to wait a few minutes for a layer of perspiration to form between your skin and your chest strap.