User Manual

6 InstantWave 11Mbps Wireless Ethernet Client
WEC Configuration Tool Installation
Before adding a WEC into an existing network, you may need to set basic
parameters, e.g. domain name (SSID), security setting (WEP), etc. in order to make
it compatible with the existing network.
Follow the steps below to connect the WEC to a PC for configuration:
step1. Connect the supplied RS-232 cable to the COM port on the WEC and
connect the other end to a serial port (COM port) on the PC
step2. Connect the power block to the electricity outlet and then to the WEC
DC5V port
step3. Insert the InstantWave WEC floppy disk into the floppy disk drive and
click Start/Run. Type a:/setup.exe
step4. Follow the on-screen instructions to complete the WEC COMFig Tool
installation