Use Instruction

ManualsBrandsNantong Jon Ergonomic Office ManualsElectronicsFull Touch 8 Key RGB Controller

I. Main parameter:

Panel controller:

Working temperature : -20-60℃

Supply voltage : DC12V

External dimension : L50×W35×H23mm

Output: 3 channel

Output current: ≦2A (each channel)

Connection mode: common anode

Touch remote:

working voltage: 1.5*3V

emission current: 10mA

working current: 300uA

standby current: 3uA

standby time: 6 months

Control distance: 25m

Color pulley point:60

II.Touch remote use instruction :

1、Touch remote have 64 touch key,each keys function below:

Color pulley: Multicolor pulley touch key,static mode choose

key,more than 60 touch points.The button has two functions:

① Pulley static color choice key ,so when the current control

mode is M key mode (color),if must realize pulley static

Summary of content (5 pages)

PAGE 1
I. Main parameter: Panel controller: Working temperature : -20-60℃ Supply voltage : DC12V External dimension : L50×W35×H23mm Output: 3 channel Output current: ≦2A (each channel) Connection mode: common anode Touch remote: working voltage: 1.5*3V emission current: 10mA working current: 300uA standby current: 3uA standby time: 6 months Control distance: 25m Color pulley point:60 II.
PAGE 2
color,can press this key. ② Pulley color switch key,can change from 60 kinds of static colors (as the pulley shown). Mode (M+、M-):this key have 2 functions: ①M is mode choose key,so when the current control mode is pulley mode(color),if you want to realize the mode (color) of M key,can press this button; ②M is mode switch key,so when the current control mode is"M"key mode,can press this button to switch the mode (color)which state in the M key mode table.
PAGE 3
stop to use the remote more than 20s，the remote will enter the stand by state(untouchable state);slightly shake once，then the remote will come back to the normal working state(touchable State). 3、Indicator light instruction: slightly shake once，then the remote will came back to the normal working state(touchable state).
PAGE 4
III:Controller connection as shown: IV.Remarks: 1.Connect the load wire at first ， following by the power wire;Please ensure short circuit can not occur between connecting wire before you turn on the power. 2.Power supply voltage range is DC12V,more than voltage range maybe will burn out the controller; 3 .Load connect must according to the connect diagram. 4.when not use it，do not put the remote on easy shake place， to extend the battery life; 5.
PAGE 5
FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.