Nanoleaf Beta User Manual
What’s in the Box Light Hexagons Mounting Plates Mounting Tapes Linkers Power Supply Controller
1 Plan your design.
2 Place a piece of mounting tape onto the flat side of the mounting plate. 3 Snap the mounting plate onto the back of a panel with tape facing outwards.
4 When mounting the first panel, snap the power supply, controller, and linkers onto the appropriate linker slot. NOTE: Snapping the power supply and controller to your first panel will ensure that your setup is on and functioning. Their positioning can be changed after your setup is complete.
5 Peel back the sticker from the mounting plate. 6 Mount the first panel on to your surface.
Continue to snap your setup together one panel at a time. NOTE: For efficient setup, always anticipate your next panel and where the linkers need to go.
Your Control Explained The Control is the brain of the Nanoleaf ULP Hexagon system. The touch control buttons on the Controller provide convenient shortcuts to common commands. The Controller can draw power from any panels in the layout or from a power supply directly. Next Rhythm Scene: Cycles through saved Rhythm Scenes Shuffle Scenes: The Controller with panels comes with hundreds of Scenes, and you can use the shuffle button to cycle through them.
Nanoleaf Smarter Series App Download the App Nanoleaf Smarter Series App Available on Open the Nanoleaf App when you are ready to pair to your Nanoleaf Canvas. The in-app tutorial will walk you through the basics of how to set up your ULP Hexagon. Pairing your Hexagon indicated by the Power LED . If the device has been on for more than 15 minutes and the Power LED has turned off, you can simply disconnect the Control Square from power to reset the timer.
Already have our Remote ? Pairing Your Remote iOS To pair with the Nanoleaf Remote in iOS, make sure the Remote lights up when you pick it up and rotate it. Open the Nanoleaf Smarter Series App and follow the in-app prompts. Android To pair with Android, you will need the Canvas. Make sure the Remote lights up when you pick it up and rotate it. Press the Rhythm button on Canvas until it starts flashing. Hold the Remote close to the Hexagon. When pairing completes, the Canvas will flash green.
FCC Warning Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.