C13260 V1.2 2022 .08 MoerDuo™ Bluetooth 5.
Introduction MoerDuo™ features with Bluetooth wireless transmit (TX) and receive (RX) switching functions, and supports both Bluetooth low energy(BLE) and classic Bluetooth standards, providing your Bluetooth devices with maximum compatibility. MoerDuo™ leads the industry, providing high-quality, low-energy, low-latency audio wireless broadcast transmission. Its Bluetooth LE Audio technology, adopts the latest LC3 codec chip in Bluetooth 5.
Instructions TX/Transmit mode 1. Switch the switch button ④ to TX/transmit mode 2. Turn on the power: press and hold the function key ① for three seconds until the LED lights up 3. Select audio transmission mode between the following 2 modes Standard Bluetooth mode (1-to-1): Double-click the function key ① , the red/blue light flashes alternately to enter the pairing mode, and the blue light flashes slowly after the pairing is completed.
Introduction to Bluetooth modes 1. Classic Audio (1-to-1) MoerDuo™ is backward compatible with non-LE Audio Bluetooth receivers. When the receiver is not a LE Audio device, it will connect using the traditional Bluetooth mode pairing method. 2. LE Audio (1-to-1) If the receiver is a Bluetooth device that supports LE Audio (including Bluetooth receivers, Bluetooth headsets, Bluetooth speakers, etc.), it will automatically use lossless/high-resolution decoding technologies to play music. 3.
Instructions of LED indicator Mode Function Status LED indicator Transmit(TX) Power Low battery/Mute Charging Charging completed Red light flashes quickly Red light stays on Blue light stays on for about 5 seconds and then turns off Standard Bluetooth Pairing Red/blue lights flash alternately Pairing completed/ Playing Blue light flashes slowly Disconnect Broadcasting Pause/ Mute Low battery Charging Charging completed Red light flashes slowly Purple light flashes Red light stays on Red light
Specification Model: AHA02 Bluetooth version: BT 5.3 LE Audio BIS, CIS Bluetooth protocol: A2DP/AVDTP/ AVCTP/ AVRCP/HFP Support audio decoding formats: SBC / AAC / LC3 / MACH Operation Mode: Pairing Mode (A2DP/CIS ) & Broadcast Mode (BIS ) Output power: 30mW@32Ω Transmit power <= 10dbm Audio input (transmitter): 3.5mm line in, USB, MIC (only a single audio source can be used at a time) Audio output (receiver): 3.
FCC This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.