RF30 USER’S MANUAL RF30 Remote & Receiver RF30 Remote RF30 Receiver © 2010 All rights reserved Printed in China http://www.namsung.
RF30 Installation Installing the RF30 Receiver 1. Connect the 3.5mm cable to the REMOTE IN input on the back of the radio. ex) WM3000RF 2. Connect the black wire from the RF30 receiver to a good ground (-) source. Typically, the ground wire connection from the radio wiring harness can be used. 3. Connect the red wire from the RF30 receiver to a 12 volt accessory switched power source. This may be connected to the red accessory power wire at the radio wiring harness.
RF30 Initial setup 1. Turn on the power to the radio and RF30 receiver. A blue LED should be visible through the top of the receiver. 2. Link the RF30 remote to the receiver by pressing and holding the MUTE button on the RF30 remote for 5 seconds, while the remote is within 3 feet of the receiver. The LED on the receiver will flash to confirm the connection. Note : this step must be repeated if the battery is remove from the RF30 remote. 3. Mount the RF30 receiver using cable ties or screws.
RF30 RF30 Specifications RF30 Remote Tx Frequency Range Channel List The Number of Channel Input Voltage Dimensions Operating Temperature Range Modulation Type 2400 ~ 2483.5 MHz 2415.4/2420.4/2425.4/2430.4/2435.4 MHz 5 DC 3 V (CR2025 Battery) 35.2 X 63.8 X 16.0 mm -10 ~ +50 ℃ GFSK RF30 Receiver Rx Frequency Range Channel List The Number of Channel Input Voltage Dimensions Operating Temperature Range Modulation Type 2400 ~ 2483.5 MHz 2415.4/2420.4/2425.4/2430.4/2435.4 MHz 5 DC 12 V 44.5 X 44.5 X 15.
RF30 FCC RF INTERFERENCE STATEMENT NOTE : The users manual or instruction manual for an intentional or unintentional radiator shall caution the user that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.