Instructions / Assembly

IMPORTANT
READ INSTRUCTIONS CAREFULLY BEFORE INSTALLING.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
ProLED
®
xtures must be wired in accordance with the National
Electrical Code and all applicable local codes. Proper grounding is
required for safety.
THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE
APPLICABLE INSTALLATION CODE BY A QUALIFIED ELECTRICIAN
WHO IS FAMILIAR WITH THE CONSTRUCTION AND OPERATION
OF THE PRODUCT AND THE HAZARDS INVOLVED.
WARNING - Risk of re or electric shock.
• Turn off electrical power at fuse or circuit breaker box before wiring
xture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire
label information.
• Make all electrical and grounded connections in accordance with the
National Electrical Code and any applicable local code requirements.
• All wiring connections should be capped with UL approved
wire connectors
Halco Lighting Technologies | 2940 Pacic Drive | Norcross, GA 30071 | Toll Free 800.677.3334 | Phone [phone] | Fax [phone] | halcolighting.com | Atlanta | Carlstadt | Cleveland | Houston | Los Angeles | Phoenix
ProLED
®
Linear LED High Bay
Installation Instructions
®
© 2016 Halco Lighting Technologies, LLC. All rights reserved. Halco is a registered trademark of Halco Lighting Technologies. All sizes and specications are subject to change.
CAUTION:
RISK OF INJURY
• Wear gloves and safety glasses at all times when removing luminaire from carton, installing, servicing or
performing maintenance .
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may be hazardous to children.
CAUTION:
RISK OF FIRE
• Keep combustible and other materials that can burn away from luminaire and lamp/lens.
• MIN 90°C SUPPLY CONDUCTORS .
IMPORTANT SAFETY INFORMATION:
CAUTION: This luminaire must be wired in accordance with the National Electric Code and applicable local codes and
ordinances. Proper grounding is required for safety.
CAUTION: Installation and servicing of this luminaire should be performed by qualied personnel only.
CAUTION: Do not use this product for other than intended use. To prevent early product failure, luminaire should only be
used in operating environments ranging from -40°C (-40°F) to 40°C (104°F).
Cleaning and Maintenance:
Caution: Do not clean or maintain while the luminaire is energized. Check that the luminaire temperature is cool enough
to touch. Periodically check and remove any accumulated dirt or debris from the lens and around luminaire.
1) Clean lens with non-abrasive glass cleaning solution.
2) Do not open the luminaire to clean the LEDs. Do not touch the LEDs.
Replacement Parts:
Contact your sales representative for replacement part availability or contact Halco Customer Care at 800.677.3334.