UWA-100 User Manual 2020/11 V1 02-2018 / v1.
I Product Information I-1 Package Content UWA-100 I-2 USB Cable Quick Installation Guide LED / button Indicator LED Color Power Red Battery Red LED Status Description On Device power on Off Device Power off On Device Battery on Mounting
Wi-Fi or BLE Recording Flashing Device low battery Off Device Battery off On Wi-Fi/ BLE wireless activity (transferring/receiving data). Quick Flashing Off Green Green Reset factory settings Wi-Fi/ BLE not active.
risk warm message during the installation process, please allow then to complete whole process. This app need two functions authority, one is location for “site survey” another “photograph” for scan QR- code. II-2 Site Survey Before deploying GWB-100, please do a site survey on the Internet Wi-Fi signal at the desired deployment location. This will ensure that the GWB-100 can remain connected to the Internet for up-to-date sensor data transfer. 1.
If the icon displays 2 bars or more signal strength, please go to the next section. If the icon displays 1 bar or no signal strength, please find another location to do the site survey process again till to find the suitable location. II-3 Connecting Device to the Internet 1. Please plug the power adapter to a power socket and connect the Device using the USB cable. 2. Open the app and tap the right corner of the screen. 3. Select the set up device from the Available wireless device list. 4.
5. Select your Wi-Fi network from the list and, where applicable, enter the Wi-Fi password. Tap the “Next” icon to complete setup. If you cannot find the desired Wi-Fi network SSID, please refresh network list. 6. Setup is complete, and please wait two minutes to check the device list.
III Internet Check Check device internet status, change the command mode to be “ ”, Select the set up device from the Available wireless device list, and click the “Internet check “ button, then will get the testing status at bottom of page. IV Reboot Setting Device reboot process to change the command mode to be “ ”, Select the set up device from the Available wireless device list, and click the “reboot “ button, then will get the testing status at bottom of page.
V OTA Setting Device OTA process to change the command mode to be “ ”, Select the set up device from the Available wireless device list, and click the “check for updates “ button will update the latest firmware version, once device version is less than this,, then will get the testing status at bottom of page.
VII Product Features VII-1 Application Secnorio The UWA-100 collects sound and data from sound identifies anomalies, classifies equipment failure modes, and predicts the problem before interrupts production. VII-2 Data Collect The UWA-100 through the microphone sensor to collect sound and data. VII-3 Web dashboard 1.
sound values are detected by UWA-100, cloud or physical server(IoT server) will notice to user. 4. Status : All of training status and testing status can be checked at this features 5. Management : User can add new UWA-100 or edit details of UWA-100 or delete current operating UWA-100 from cloud or physical server(IoT server). 6. Alert notice : User can see all abnormal detected cases here and compare between randomly created standard spectrogram image by AI and abnormal spectrogram image.
FCC 警語 FEDERAL COMMUNICATIONS COMMISSION INTERFERENCE STATEMENT This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.