Owner`s manual

ManualsBrandsMyryad ManualsDVD PlayerZ122

Z-SERIES

Z142Remote Controlled Integrated Amplifier

Stortford Hall Industrial Park, Dunmow Road

Bishops Stortford, Hertfordshire, CM23 5GZ

This symbol means do not dispose of as municpal waste.

Re-use or recycle wherever possible. Electrical/Electronic

Equipment may contain substances harmful to the

environment. For environmentally sound methods of disposal,

please contact your local government agency.

Revision: 1

www.armourhe.co.uk

w ww .m yr ya d. co .u k

Owner’s manual

142

Summary of content (8 pages)

PAGE 1
Stortford Hall Industrial Park, Dunmow Road Bishops Stortford, Hertfordshire, CM23 5GZ www.armourhe.co.uk Z-SERIES Z142 Remote Controlled Integrated Amplifier Owner’s manual This symbol means do not dispose of as municpal waste. Re-use or recycle wherever possible. Electrical/Electronic Equipment may contain substances harmful to the environment. For environmentally sound methods of disposal, please contact your local government agency. Revision: 1 142 www.myryad.co.
PAGE 2
CONTENTS • • • • • • • • • • • Introduction Installation and Safety Accessories Setting up your Amplifier Rear panel connections Operating your Amplifier Front panel controls Loudspeaker Output Protection and Muting Remote Control Handset Operation System Operation with Smart My-Link Installing and Replacing Batteries Trouble-shooting guide Specifications 2 2 2 3 5 6 6 7 7 7 7 INTRODUCTION INSTALLATION AND SAFETY The Myryad Z142 Integrated Amplifier has been designed to offer a combination of high qual
PAGE 3
SETTING UP YOUR AMPLIFIER REAR PANEL CONNECTIONS 1 Power inlet Before making any connection, check that the mains voltage setting printed on the rear panel is the same as your local mains supply. Plug the female (socket) end of the power cord into the power inlet on the rear of the amplifier. Plug the male (plug) end of the cord into a “live” wall socket or a suitable heavy duty extension cable.
PAGE 4
7 Tape 2 input/output These connectors are suited to any type of tape or CD recorder, but “off-tape” monitoring is not possible using TAPE 2. The wiring from TAPE 2 to your tape deck is identical to the TAPE 1 wiring described above. 11 Phono/Aux switch This switch is used to select between the PHONO and AUX inputs described below. With the switch released (button protruding) the signals from a record player connected to the PHONO input will be heard when the PHONO input is selected.
PAGE 5
OPERATING YOUR AMPLIFIER FRONT PANEL CONTROLS 1 Standby When amplifier is plugged into a live wall socket and the POWER switch is turned ON, it will power up in “standby” mode and the LED (Light Emitting Diode) by the STANDBY button will glow red. In this mode the internal circuitry is powered up, but disabled so that it consumes very little power and the loudspeaker outputs are muted by a relay. 4 Headphone socket The headphones socket will accept a standard 3.5mm stereo jack plug or adapter.
PAGE 6
LOUDSPEAKER OUTPUT PROTECTION AND MUTING REMOTE CONTROL HANDSET OPERATION When the amplifier is in standby mode the loudspeaker output terminals are isolated from the amplifier by high quality relays. When the amplifier is first switched on from standby mode the loudspeaker outputs remain disconnected for a few seconds to allow the internal voltage levels to settle. The same process occurs when the amplifier is switched back into standby mode.
PAGE 7
SYSTEM OPERATION WITH SMART MY-LINK® INSTALLING AND REPLACING HANDSET BATTERIES When used as a linked system (which must include a Smart MyLink® equipped Integrated Amplifier like the Z142, or a Preamplifier) Myryad products equipped with Smart My-Link® have a number of extra features that make the system as a whole easier and quicker to use than a normal hi-fi. These include: The MSR2 Remote Handset uses two 1.5 V type AAA batteries.
PAGE 8
Stortford Hall Industrial Park, Dunmow Road Bishops Stortford, Hertfordshire, CM23 5GZ www.armourhe.co.uk Z-SERIES Z142 Remote Controlled Integrated Amplifier Owner’s manual This symbol means do not dispose of as municpal waste. Re-use or recycle wherever possible. Electrical/Electronic Equipment may contain substances harmful to the environment. For environmentally sound methods of disposal, please contact your local government agency. Revision: 1 142 www.myryad.co.