Quick Start Guide

ManualsBrandsMYLAPS ManualsElectronicsX2 BaseLink

QUICK START GUIDESUPPORT

BASELINK

MYLAPS EMEA Oce

Haarlem, The Netherlands

Tel: +31 23 7600100

Email: support@mylaps.com

MYLAPS Americas Oce

Atlanta, USA

Tel: +1 (678) 816 4000

Email: info.americas@mylaps.com

MYLAPS Japan Oce

Tokyo, Japan

Tel: +81 3 5275 4600

Email: info.japan@mylaps.com

MYLAPS APAC Oce

Sydney, Australia

Tel: +61 (0)2 9546 2606

Email: info.asia.pacic@mylaps.com

MYLAPS Asia Oce

Selangor, Malaysia

Tel: +60 (0)356131235

Email: info.asia@mylaps.com

In case you encounter any issues,

please contact your sales oces:

version 1.0 | art. #1702030906

Summary of content (5 pages)

PAGE 1
SUPPORT QUICK START GUIDE In case you encounter any issues, please contact your sales offices: MYLAPS EMEA Office MYLAPS Americas Office Haarlem, The Netherlands Atlanta, USA Tel: +31 23 7600100 Tel: +1 (678) 816 4000 Email: support@mylaps.com Email: info.americas@mylaps.com MYLAPS Japan Office MYLAPS APAC Office Tokyo, Japan Sydney, Australia Tel: +81 3 5275 4600 Tel: +61 (0)2 9546 2606 Email: info.japan@mylaps.com Email: info.asia.pacific@mylaps.
PAGE 2
WHAT IS IN THE BOX? BASELINK Ethernet Cable 25m X2 BaseLink Cable Strain Relief Ethernet Cable 2m 1x 1x Power Cable POE Injector Required, not included X2 Decoder 2 X2 Server Orbits 5.
PAGE 3
QUICK START GUIDE BASELINK 1 INSTALLING A Installation Diagram Timing Software* An obstacle free line of sight is required. The range is 500 - 1000 meters. Obstacle can cause interference including trees, buildings, dunes, water and steel objects. Pipe diameter is Ø 42.4 mm (1.74 inch/size 7). Use a 8 mm allen wrench to mount BaseLink on pipe.
PAGE 4
QUICK START GUIDE BASELINK 2 CONNECTING A Connect X2 server to the Timing Software B Connect to the X2 BaseLink* Connect the X2 BaseLink to the X2 Server. Then enable the Onboard Feed to use the Baselink to send messages to the Racers. Use Orbits 5.3 or higher (or other supported 3rd party software).
PAGE 5
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Warning (part 15.21) Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. Information to the User (Part 15.