Elevator IOT Machine Model- SOTL5-b
Packing List Before setting up your product, please make sure the following items have been shipped: 1- SOTL5 If any of these items are missing or damaged, please contact your distributor or sales representative immediately.
Copyright Notice This document is copyrighted, 2019. All rights are reserved. The original manufacturer reserves the right to make improvements to the products described in this manual at any time without notice. No part of this manual may be reproduced, copied, translated, or transmitted in any form or by any means without the prior written permission of the original manufacturer. Information provided in this manual is intended to be accurate and reliable.
About this Document This User’s Manual contains all the essential information, such as detailed descriptions and explanations on the product’s hardware and software features (if any), its specifications, dimensions, jumper/connector settings/definitions, and driver installation instructions (if any), to facilitate users in setting up their product. Users may refer to the Datahoist.com for the latest version of this document.
Safety Precautions Please read the following safety instructions carefully. It is advised that you keep this manual for future references 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15. All cautions and warnings on the device should be noted. Make sure the power source matches the power rating of the device. Position the power cord so that people cannot step on it. Do not place anything over the power cord. Always completely disconnect the power before working on the system’s hardware.
Federal Communications Commission Statement This device complies with Part 15 FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received including interference that may cause undesired operation. Caution: This equipment has been tested and found to comply with the limits for a class A digital device, pursuant to Part 15 of the Federal Communications Commission (FCC) rules.
SOTL5 Monitor IO There are 8 inputs in 2 terminal blocks of 4 each. Each block has its own reference. The figures below show an example pull sheet, but it can be wired in any combination that works for the car it's installed on. Each block supports one logic circuit supply from 24 – 120 v ac or dc. Low voltage monitoring (below 60 volts) is accomplished with a jumper installed on a 2 pin header in front of the wire terminal The unit is powered by 100-240 vac from the cartop as well.
3/4" flex and multi-conductor for the power and logic circuits is needed for installation. 12 at most on the multiconductor of wires 18 – 20 ga stranded. Instructions for Installation 6. 7. 8. Customer shall determine which elevator unit they will install the device on, and determine signal voltages and car top terminal names for the following. Measure and record: 1. Power (Can be safety circuit or logic common) 2. Inspection 3. Door Open Limit 4. Door Close Limit 5.
Incoming power (100-240 vac) to the unit is wired to pin 1-Neu and pin 5- Line. Wires should be 18 to 20 ga stranded. 4 inputs each are wired to Block 1 and Block 2, with the reference being on terminal 1 (first from the left) on each block. Wires should be 18 to 20 ga stranded. Once installed the unit connects to the Datahoist cloud and the operation can be observed via the dashboard by logging in with credentials supplied by your Datahoist contact.
