Quick Guide EN DE FR IT ES NL PT SW DK TU PL GR RU FI TC Headset
Model No.: MBT-H120 FCC ID: HWF-MBTH120 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate FOR HOME OR OFFICE USE equipment.
Identifying the Parts 2. Power / Talking Button 3. Volume Down EN 1. Volume Up / Pairing Button 1 2 3 4 4. Indicator LED Red : Power Off 5 6 Blue : Power On Red+Blue : Pairing mode 5. Earhook 7 6. Earphone 7. Microphone 8 8.
Charging the Battery First time use: Please charge the built-in Li-ion battery for 24 hours before the initial use. Low battery: When the battery is low, the indicator LED will flash red. Please charge the battery for approximately 2.5 hours. How to charge: 1. Connect one end of the supplied AC Adapter (5V/0.5A) to the DC IN jack on the headset and the other end to the wall outlet. The indicator LED will light red when charging. After fully charging the battery, the indicator LED will light out.
Wearing the Headset Wearing the Headset To wear on your left ear: Wear the headset vertically on your left ear. (Please refer to Figure 1) Rotate the headset toward the rear of your ear and point the microphone toward your mouth. (Please refer to EN You can wear the headset on either ear with the reversible earhook. To wear on your right ear: Reverse the earhook to change its direction, and then follow the steps above to wear it on your right ear.
Powering the Headset On or Off To power your headset on: Press the Power button for approximately 2 seconds until the indicator LED starts to flash blue. Then you can start to operate your headset. To power your headset off: Press the Power button for approximately 2 seconds until the indicator LED starts to flash red. Once the indicator LED stops flashing, the power is OFF.
Pairing with a Bluetooth Phone To pair with a Bluetooth phone, please follow the instruction below: Ensure the headset is ON and enters the standby mode with flashing blue LED once rapidly every 3 seconds. ( Note: When powered on, the headset will attempt to connect to an available Bluetooth device. Please press the Power button to switch to the standby mode. ) 2.
Pairing with a Bluetooth Phone-continue If you have entered the passkey without previously pairing with another phone, the phone will be the “default phone” for your headset. If you want to use another Bluetooth phone with your headset, please switch the headset off, then disconnect it from the previous phone. Next, pair with another phone once restarted as described in page 7.
Call Functions When receiving a call, you will hear a ring tone through the headset’s earphone. Press the Power/Talk button to answer or end a call. To make a call: There are two ways to make a call: 1. Using your phone’s keypad: Press the Number button you want to call in your phone’s keypad to make a call. 2. Using the “Voice Dialing” function through your headset: 1) Record “Voice Tags” in your phone address book in advance. 2) Ensure this function is ON.
Headset Indicator LED While plugging in the charger: Indicator LED Headset Light Red Charging Light Out Full Charge While unplugging the charger: Indicator LED Headset Flash Red Low Battery Flash Red Light Out Power Off Flash Blue Power On Flash Red and Blue Alternately Pairing Mode 10 BLUETOOTH HEADSET GETTING STARTED Flash Blue LED once rapidly every 3 seconds Signal Available (Standby Mode) Flash Blue LED twice rapidly every 3 seconds Connecting Flash Blue LED 3 times rapidly every