Quick Guide EN DE FR IT ES NL PT SW DK TU PL GR RU FI TC Dongle
Model No.: MBT-D120 FCC ID: HWF-MBTD120 This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation. Tested To Comply With FCC Standards FOR HOME OR OFFICE USE Any changes or modifications not expressly approved by the party responsible for compliance could void the authority to operate equipment.
EN Introduction Thank you for purchasing the Bluetooth USB Dongle! This device allows for wireless communication between your computer and other Bluetooth enabled devices. Quick Guide Please thoroughly read this guide in order to properly install the Dongle and device drivers. Note: Please ‘pair’ the Dongle and Bluetooth device in order to enable proper communication.
Driver Installation Before using the USB Dongle, please follow the steps below to install the bundled CD driver. 1. Insert the installer CD into your CD-ROM drive. 2. Close the CD-ROM drive. 3. After the CD menu appears, double-click “ Setup.exe” icon to start the installation. 4. An installer wizard will automatically launch, then click “ Install” button to continue.
Driver Installation EN (Figure 2) Note: Please follow the screens to complete installation. 6. Please plug in the USB Dongle to a free USB port when prompted to do so and click “OK” button. (Please refer to Figure 3) (Figure 3) 7. It will take several minutes to execute installation.
Driver Installation “Finish“ button to complete installation. (Please refer to Figure 4) (Figure 4) 8. Please reboot your computer after the installation is complete. (Please refer to Figure 5) (Figure 5) 9. The icon “ ” will display on the Windows taskbar. Then, you can start to use the Bluetooth Dongle.