User's Manual

09 October 2020

LBEE5XV1XA User Manual for FCC

*If it is difficult to describe this statement on the host product due to the size, please describe in the User's manual.

please describe in the user's manual and also either describe on the device packaging or on a removable label attached to the device.

or Contains Transmitter Module FCC ID:VPYLBEE5XV1XA Contains FCC ID: VPYLBEE5XV1XA

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation.

● The following information must be indicated on the host device of this module.

Model Name: LBEE5XV1XA, LBEE5XV2BA, LBEE5XV1ZA

FCC ID:VPYLBEE5XV1XA

Since this module is not sold to general end users directly, there is no user manual of module.

For the details about this module, please refer to the specification sheet of module.

This module should be installed in the host device according to the interface specification (installation procedure)

The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove

this RF module in the end user’s manual of the end product which integrates this module.

The end user manual shall include all required regulatory information/warning as shown in User manual.

PAGE 1
LBEE5XV1XA User Manual for FCC Model Name: LBEE5XV1XA, LBEE5XV2BA, LBEE5XV1ZA FCC ID:VPYLBEE5XV1XA Since this module is not sold to general end users directly, there is no user manual of module. For the details about this module, please refer to the specification sheet of module.
PAGE 2
LBEE5XV1XA User Manual for FCC ●The following statements must be described on the user manual of the host device of this module; FCC CAUTION Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This transmitter must not be co-located or operated in conjunction with any other antenna or transmitter. When installing it in a mobile equipment.
PAGE 3
LBEE5XV1XA User Manual for FCC Compliance with FCC requirement 15.407(c) Data transmission is always initiated by software, which is the passed down through the MAC, through the digital and analog baseband, and finally to the RF chip. Several special packets are initiated by the MAC. These are the only ways the digital baseband portion will turn on the RF transmitter, which it then turns off at the end of the packet.