User's Manual

ManualsBrandsMurata Manufacturing ManualsElectronicsCommunication Module

08 January 2016

LBEQ6ZZ1ES Installation Manual for FCC

FCC ID of this product is as follows.

FCC ID: VPYLB1ES

Contents

1. PIN Layout

2. Supply Voltage

3. Power Levels

4. Notice

Please make sure that your product has been evaluated and

confirmed from the aspect of the fitness for the specifications and this

documentation of our product.

Summary of content (7 pages)

PAGE 1
LBEQ6ZZ1ES Installation Manual for FCC Please make sure that your product has been evaluated and confirmed from the aspect of the fitness for the specifications and this documentation of our product. FCC ID of this product is as follows. FCC ID: VPYLB1ES Contents 1. PIN Layout 2. Supply Voltage 3. Power Levels 4. Notice Copyright © Murata Manufacturing Co., Ltd. All rights reserved.
PAGE 2
1. PIN Layout M D123 1ESxxx 123456789ABCDE Model:LBEQ6ZZ1ES FCC ID:VPYLB1ES IC:772C-LB1ES No. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 PIN NAME GND GND GND NC NC NC GPIO0 TCK TMS TDI TDO GPIO1 GND NC GND VIO GND PCM_IN PCM_OUT PCM_CLK No. 21 22 23 24 25 26 27 28 29 30 31 32 33 34 35 36 37 38 39 40 PIN NAME PCM_SYNC GND SD_CLK SD_CMD SD_D0 SD_D1 SD_D2 SD_D3 GND GND VBAT GND PDn UART_TX UART_RX UART_CTS UART_RTS NC GND NC No.
PAGE 4
3. Power Levels Mode IEEE 802.11b IEEE 802.11g IEEE 802.11n Setting Power [dBm] 17 13 13 Mode IEEE 802.11a IEEE 802.11n (HT20) IEEE 802.11n (HT40) IEEE 802.11ac (HT20) IEEE 802.11ac (HT20 IEEE 802.11ac (VHT80) Setting Power [dBm] 14 14 13 8 8 8 Mode BT BLE Setting Power [dBm] 7 7 Copyright © Murata Manufacturing Co., Ltd. All rights reserved.
PAGE 5
4. Notice Federal Communication Commission Interference Statement This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 6
4. Notice Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. Copyright © Murata Manufacturing Co., Ltd. All rights reserved.
PAGE 7
4. Notice This device is intended only for OEM integrators under the following conditions: 1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and 2) The transmitter module may not be co-located with any other transmitter or antenna. 3) The use of an antenna with gain less than 2.07 dBi (for 2.4GHz) and 2.43 dBi (for 5GHz) As long as 2 conditions above are met, further transmitter test will not be required.