Installation and Operation Manual Regulatory Model: N01PC Regulatory Type: N01PC001
Notes, cautions, and warnings NOTE: A NOTE indicates important information that helps you make better use of your computer. CAUTION: A CAUTION indicates either potential damage to hardware or loss of data and tells you how to avoid the problem. WARNING: A WARNING indicates a potential for property damage, personal injury, or death.
Overview The Dell Embedded Box PC 5000 series allows you to connect (wired or wireless) to network enabled devices and manage them remotely in your existing network ecosystem. The system can be either mounted on the wall using the Dell approved wall mount kit or mounted into your existing rack infrastructure using the Rail mount. The system is running on Windows 10, Ubuntu, and Wind River Linux operating systems.
System Features Top - View Feature 1 Expansion-card slot 1 2 Expansion-card slot 2 3 Power button 4 Remote power switch 5 Hard reset 6 USB 3.0 port (4) 7 Network port (2) 8 DisplayPort (2) 9 HDMI port 10 CANbus port 11 VGA port 12 +19.5 VDC power port (barrel connector) 13 Audio ports (3) 14 +24V DC power Phoenix connector Supports an optional PCIe discrete graphics solution, 20-25W(12V/2A) graphics card and 10W thermal capability.
Bottom - View 1 2 3 Feature GPIO-in 9 pin port GPIO-out 9 pin port USB 2.
Setting up your Dell Embedded Box PC 5000 WARNING: When installing the system, the responsible party or integrator shall use the AC Adapter provided with the system, or connect to a 12-26 Vdc power source already present as part of the clients installation If ambient temperature of the installation exceeds 40'C then use the 12-26 Vdc power available as part of the installation.
Powering on the system WARNING: Connect power to either Phoenix Connector or the Barrel Connector only. Connecting to both power sources may damage equipment and present a fire risk. 1. 2. 3. 4. 5. 6. 7. Install the system on the wall mount using the Dell approved wall mounting kit. or Install the system on the rack infrastructure using the Dell approved DIN-rail mounting brackets. Connect the network cable. or Install the wireless antenna to enable the wireless connections Connect a display to the system.
2. Drill four holes in the wall that correspond to the holes in the mounting bracket, then place the system against the wall and align the holes in the mounting brackets with the holes in the wall.
3. Tighten the screws to secure the system to the wall.
USB Communications Wi-Fi Bluetooth Four RS232 port Four USB 3.0 port Two USB 2.0 ports Dual-band 802.11b/g/n/ac Bluetooth 4.1 LE Power requirements Phoenix connector input 12-26V voltage/current 10.8A-5A (130W) Power input 12-26V voltage/current 10.8A-5A (130W) WARNING: Connect power to either Phoenix Connector or the Barrel Connector only. Connecting to both power sources may damage equipment and present a fire risk.