ssa pn armband 2.1 What can you check if nothing works? Transmitter and receiver crystals Same channel in transmitter and receiver? Reload base type +f you think fiat the data for the stored model has been changed ds a result of your programming experiments, you can re-load the base type.
i PROF me 4000 3. The first fixed-wing model {Helicopter < p. 12). Tha basic preparations are alleviated Slightly Hers as. they have already been described under the same section Jet tars In Section 1.) The first that (= page 6 on). 8 3.
IEE Aas At this paint you should sst the transmitter's modulation to match the receiver you will be using: if your receiver you don't need to make any changes. You can move straight on to point 34. 3.4 Changing the control assignments Nate: the control will be Interchanged! For example, if you assign RUDDER transmitter control A, AILERON will automatically be switched fo . control C.
$ PROF mc 4000 Quick start 3.5 Connecting servos You have to repeat thé following steps for ail servos. ng | 44 Open “SERVO fi Recommendation: leave the serve I S or old unchanged if you want's quick stars! Select the servo: with, B/E) or the Distortion.
~ PROF me 4000 At this point you should sét the transmitters modulation to the receiver which vou will be using. If your receiver you font need to make any changes. You Can move straight on to point Quack start 4.4 Changing the tricolor assignments Note: the colorists will ba interchanged! BEVIES" Mt this arrangement sluts your preferred dying mode, “you can move or directly to point. 4:6 *Congealing 4.3.
| Quick start 4.6 Connecting servos You have to repeat the following steps for all ser The servos must be connected as sited In the table below.