User's Manual

• Releasethelidscrewandopenthelid.
• Insertbaeries
(2xAA)accordingto
the"+""-"signs.
GreenLEDwill
illuminatefor2
seconds.
• Closethelidand
ghtenthescrew.
• Touch[#]for5seconds.
Thereaderwillselfcalibrate,whichwill
befollowedbyaseriesofbeepsand
blinkingLEDs.
1. Baery Replacement
EnterDate
Press[OK]
EnterTime
Press[OK]
Press[OK]
3. Adjust Date & Time
2. Pairing Fingerprint Reader
Thisprocedureisdoneviathe
smartphoneapplicaon.
Seealso:PairingTouchpadReader.
Openthesmartphoneapplicaon.
Pressonthelockicon
ontherightsideat
thetop.
Pressonlocksengs
fromthelist.
Presson“Addional
ControlUnits”.
Presson“+Add”
buonlocatedunder
“WallReader”.
Typeinowner
password.
2LED’sblinkinginthe
doorunit.
Thelockiswaing
forthengerprint
tocreatethe
connecon.
Press#5towake-upthe
FingerprintTouchpad.
2shortbeepsemied.
Press[OK]
Note: during the pairing process 2 green lock
signs blinking in the door unit.
Pairing OK
[OK]indicaonblinks
once.
2shortbeepsemied.
Fingerprint Reader
added.
Pairing failed
1longbeepemied.
RedLEDilluminatedfor
2seconds.
Intheappscreen:
“Pairingprocesshadfailed.Pleasetryagain”.
Note:Attheendoftheinialpairingprocess,
ashortnocewillbedisplayed.
SengaMasterUserrequiresboth
ngerprintandPINcode.Itispossibleto
haveuptotwoMasterUsers.
Note: Atanystageyoucanpressandhold
the[
*
]keytomovetostandbymode.
4. Add Master User
Typein[Master name] [OK]
Set PIN code
Press[OK]
Typein[PIN Code],
(4to10digits).
Press[OK]
Retype[PIN Code]
Press[OK]
Matched Codes
Mismatched
Codes
GreenLEDblinking
ADD USER
SET FINGER
Set Finger
BlueLEDilluminates
Press[OK]
Placengeronscanner,waitforbeep,
thenswipengerdownseveralmesover
ngerprintscannerunltwoconrmaon
beepsemied
GreenLEDblinking
Placengeronscanner,waitforbeep,
thenswipengerdownseveralmesover
ngerprintscannerunltwoconrmaon
beepsemied.
5. Unlock the Door
Opon 1:
Placengeronngerprint
scanner.
Shortbeepemied&white
LEDilluminates.
Swipengeroverngerprint
scanner.
Fingerprint authorized:Blue
LEDblinksandunlockcommandissent.
Fingerprint not authorized:RedLED
illuminates.Thedevicegoestostandby.
Opon 2:
TouchtheFingerprint
Touchpad.
Screenpromptsforusercode.
Enteryourcode [OK]
Note:Intheevent,theunlockingaempt
fails,1longbeepemied.
RedLEDilluminatedfor2seconds.
6. Lock the Door
TouchtheFingerprintTouchpad.
Press[1] [#]
7. Seng Menu
8. Add User
Theunitsupportupto20users.
Foreachuser,twodierentngerprints
andonePINcode.Usedierentusername
foreachuser.
1 2
Press [OK] Press [OK]
3 4
Choose[OK]toadd
2ndMasterUseror
[
*
]toaddauser.
Note:Thisscreen
willnotappeariftwo
MasterUsersare
dened.
Type[USER NAME]
[OK]
Press[
*
]
Touchscreen
Enter [Master PIN
Code] [OK] or
swipengerover
ngerprintscanner
User name
added
User name
exists
Sameusername.
Choosedierent
username.
5 6
Press [OK] toseta
ngeroruse[8
▼
]
or[2
▲
]inorderto
setacodeonly.
Swipe1stnger
severalmes
overngerprint
scannerunltwo
conrmaonbeeps
sound.
Swipe2ndngerseveral
mesoverngerprint
scannerunltwo
conrmaonbeepssound.
7 2nd nger added
8 9
Press [OK] forYES or
[
*
] forNO
Type[CODE]
[OK]
10
Retype[CODE]
[OK]
Matched Codes
Mismatched
Codes
Note: verify the app is closed.
11. Enable/Disable User
Press[
*
]
Enter [Master PIN
Code] [OK] or
swipengerover
ngerprintscanner
1 2
Press [OK] Use[8
▼
] or[2
▲
]
toselect:
[ENABLE USER]
[OK]
9. Low-baery Indicaon
FingerprintReaderLow-baeryIndicaon:
RedLEDilluminatesfor1secondaer2long
wake-upbeepsareemied.
10. Delete Fingerprint Reader
Pressontheremove
switch.
PressYes.
ENABLE USER
JENNIFER
Disabled
3 User enabled
Use[8
▼
] or[2
▲
]
totogglebetween
users.Press [OK]
Note:Repeatthisproceduretodisable
auser.