Field Radio Installation Manual 880-0047-001 Rev 1 This Mueller Systems proprietary and confidential document shall not be reproduced or retransmitted in any way without expressed written consent from Mueller Systems
Field Radio Installation Manual Document Information Title: Version: Created: Last Modified On: Author: Technical Lead: Contributors: Field Radio Installation Manual 0.1 7/7/2010 7/7/2010 DES Revision History Date 0.1 7/7/2010 Author Comments DES • Initial draft, submitted for review • • Reviewers Reviewed By Rev 1.
Field Radio Installation Manual Table of Contents 1. Introduction ................................................................................................................................................ 5 2. Supported Products .................................................................................................................................... 5 3. Maintenance ..............................................................................................................................
Field Radio Installation Manual FCC Information: Changes or modifications not expressly approved by Mueller Systems could void the user's authority to operate the equipment. IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
Field Radio Installation Manual 1. Introduction The Mueller Field Radio is intended for indoor & outdoor use as an automatic metering Infrastructure (AMI) & control device. The Field Radio product consists of a Mueller RFDC radio limited module fully integrated with a main board consisting of an AC/DC regulated switching power supply and RS232 interface.
Field Radio Installation Manual 4.2 FCC Identification This label is affixed to the side of the Field Radio enclosure and indicates the FCC ID This product contains Module FCC ID: SM6-RFDC This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions; (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Figure 2 - FCC Label Rev 1.