Mi.
Mi.Node M Installation Manual Contents 1. Introduction ................................................................................................................................ 4 2. Construction ................................................................................................................................ 4 3. Installation .................................................................................................................................. 5 3.1 Pit Set Installation ....
Mi.Node M Installation Manual FCC Information: Changes or modifications not expressly approved by the Mueller Systems could void the user's authority to operate the equipment. IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
Mi.Node M Installation Manual 1. Introduction The Mueller Systems Mi.Node M is intended for indoor and outdoor use as an unattended Automatic Metering Infrastructure (AMI) and control device. The Mi.Node M is fully self-contained and battery powered device with no user accessible controls. The Mi.Node M for Residential Metering (“Mi.
Mi.Node M Installation Manual There are no customer serviceable parts inside the Mi.Node M housing. Batteries are not replaceable. The electronic design utilizes the latest RF microchip technology which increases reliability when compared to older RF designs. 3. Installation Mi.Node M modules support two mounting options, either mounting to a ½” PVC pipe for pit set installations or affixed to the side of a building.
Mi.Node M Installation Manual 2. Mi.Node M can be directly mounted to almost any flat surface by using the holes shown and common screws in most instances. 3. Vertical orientation of the device is required to maximize RF performance. 3.3 Wiring Tools Required: 3M-2Y connectors, splitting tube, and a 3M Crimping Tool Mi.
Mi.Node M Installation Manual Figure 1. Sample Product Identification Label 5.2 IC Information This AMI t r a n s m i t t e r , model Mi.Node M, operates in the license exempt 902 MHz to 928 MHz ISM band and is certified for operation in Canada. The IC ID is 9235A-MINODEM. Information pertaining to the certification can be found on the web at http://www.ic.gc.ca/eic/site/ceb-bhst.nsf/eng/home.