MiHub 1.
MiHub 1.5 XR Installation & Operation Manual Table of Contents 1 FCC Information .................................................................................................................................... 3 2 IC Information ....................................................................................................................................... 4 3 Authorized Antennas .................................................................................................................
MiHub 1.5 XR Installation & Operation Manual 1 FCC Information Changes or modifications not expressly approved by the Mueller Systems could void the user's authority to operate the equipment. IMPORTANT NOTES: To comply with FCC RF exposure compliance requirements: 1) The antenna used for this 915 MHz transmitter must be installed to provide a separation distance of at least 23 cm from all persons during normal operation.
MiHub 1.5 XR Installation & Operation Manual 2 IC Information Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
MiHub 1.5 XR Installation & Operation Manual L’antenne pour cet appareil doit être positionnée au moins de 20 cm de n’importe quelle autre antenne d’émission. 3 Authorized Antennas This radio transmitter has been approved by Industry Canada and FCC to operate with the antenna types listed below with the maximum permissible gain and required antenna impedance for each antenna type indicated.
MiHub 1.5 XR Installation & Operation Manual 6 MiHub 1.5 XR Installation & Operation: The MiHub 1.5 XR main unit is a 7.3” x 10.4” x 3.7” NEMA 4 plastic box which contains weighs approximately 2.5 lbs. It dissipates between 4 watts (standby) & 15 watts (worst case scenario). Typically, the MiHub 1.5 XR is fastened to a tower support or wall of a collocated structure and then power is attached & applied. A MiHub 1.5 XR unit has both GPRS (side mounted) & 915 MHz (remotely mounted) antennas.
MiHub 1.5 XR Installation & Operation Manual The bottom of the MiHub 1.5 XR has a power cord attached in the middle. To the left of that is an air vent. To the right of the power cord is the 915 MHz antenna connection (N‐type female) and a green LED to indicate that the unit is powered up. On the right side is the GPRS antenna. A pre‐drilled mounting plate is attached to both the top & bottom of the main unit. There are no other (operator/installer) accessible controls or displays. Any use of the MiHub 1.
MiHub 1.5 XR Installation & Operation Manual 8 8.1 Product Identification and Safety Labels & Locations MiHub 1.5 XR Unit Labels: Electric Shock Hazard Warning Finished Goods Label 5.3 Label Locations 9 FCC Identification Labels This is illustration of text used on FCC label for MiHub 1.5 XR. Below is the text for the FCC declaration label for the GPRS modem Module. This product contains Multi-Tech modem FCC ID: AU792U03G23720 This device complies with Part 15 of the FCC Rules.