Certification Exhibit FCC ID: SM6-HOTRODV2ML IC: 9235A-HOTRODV2ML FCC Rule Part: 15.249 IC Radio Standards Specification: RSS-210 ACS Project Number: 12-0115 Manufacturer: Mueller Systems Model: AHRML-DL Manual 5015 B.U.
HOTRODV2 Installation Manual PN 880-0083-001 Rev 0.
HOTRODV2 INSTALLATION MANUAL Document Information Title: Version: HOTRODV2 Installation Manual 0.8 Created: 11/15/11 Last Modified On: 5/24/2012 7:25 AM Author: Technical Lead: Contributors: Revision History Version Date Author Comments Reviewers Reviewed By Page ii Title Date Reviewed Mueller Systems, LLC Rev 0.
HOTRODV2 Installation Manual Table of Contents 1. 2. 3. 4. 5. 6. Introduction .............................................................................................. Product Features ....................................................................................... CONNECTING AND OPERATING THE MUELLER AMR TRANSMITTER ............ AMR TRANSMITTER TROUBLE SHOOTING .................................................. FCC INFORMATION ..................................................................
HOTRODV2 INSTALLATION MANUAL FCC Information Changes or modifications not expressly approved by Mueller Systems, LLC could void the user's authority to operate the equipment. IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter.
HOTRODV2 Installation Manual IC Information Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential radio interference to other users, the antenna type and its gain should be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
HOTRODV2 Installation Manual 1. Introduction This document is intended to assist professional installers with Mueller Systems AMR transmitters. It provides instructions on how to successfully connect, operate, and troubleshoot the transmitters. Mueller’s remote meter reading transmitters were designed with an “easy to install approach” for utilities. The AHRAG-DL, AHRPL-DL, and AHRML-DL allow the utility to receive data from any Mueller water meter equipped with a Translator register.
HOTRODV2 INSTALLATION MANUAL connections against damage. Please note that this does not mean meters or registers can be carried while supported only by the AMR transmitter or wiring. 3. CONNECTING AND OPERATING THE MUELLER AMR TRANSMITTER The AMR transmitter is preprogrammed prior to being attached to the meter. All pit set units come with either 5’ or 25’ of wire attached and potted at the factory as specified.
HOTRODV2 Installation Manual Figure 3 To attach the AMR transmitter, wire the red wire to terminal #1, the green wire to #2, and the black wire to terminal #3 on the TRU-Read,Figure 3. Once the transmitter is attached it will begin sending out data automatically. Please note that Mueller Systems AMR transmitter and TRU-Read should never be disassembled or user serviced. 4.
