User Manual

ManualsBrandsMueller Systems ManualsElectronicsAMR Transmitter

Table Of Contents

5015 B.U. Bowman Drive Buford, GA 30518 USA Voice: 770-831-8048 Fax: 770-831-8598

Certification Exhibit

FCC ID: SM6-HOTRODV1LO

FCC Rule Part: 15.249

ACS Project Number: 12-0115

Manufacturer: Mueller Systems

Model: AHRV1LO-DL

Manual

Summary of content (4 pages)

PAGE 1
Certification Exhibit FCC ID: SM6-HOTRODV1LO FCC Rule Part: 15.249 ACS Project Number: 12-0115 Manufacturer: Mueller Systems Model: AHRV1LO-DL Manual 5015 B.U.
PAGE 2
PRODUCT GUIDE FOR THE AMR TRANSMITTER OVERVIEW This document is intended to assist professional installers with Mueller Systems’ AMR transmitters. It provides instructions on how to successfully connect, operate, and troubleshoot the transmitters. Mueller Systems’ remote meter reading transmitters were designed with an “easy to install approach” for utilities. The SM6-HOTRODV1LO allows the utility to receive data from any water meter equipped with a Translator register.
PAGE 3
CONNECTING AND OPERATING THE MUELLER AMR TRANSMITTER The AMR transmitter is preprogrammed prior to being attached to the meter. All pit set units come with either 5’ or 25’ of wire attached and potted at the factory as specified. If a retro fit is required, the wires should be spliced to the existing wires coming from the register. Wire the red to red, green to green, and black to black wires using 3M UY2 Scotchlok splices with the E-9Y application Figure 3 tool.
PAGE 4
AMR TRANSMITTER TROUBLE SHOOTING PROBLEM POOR RANGE NOT TRANSMITTING CORRECT DATA NOT TRANSMITTING POSSIBLE CAUSE CHECK ORIENTATION OF THE HOT ROD ANTENNA CHECK THE RECEIVER ANTENNA CHECK FOR INTERFERENCE CHECK WIRING CONNECTIONS CHECK WIRES FOR SHORT CHECK FOR INTERFERENCE CHECK DISTANCE TO RECEIVER CHECK TRANSLATOR STATUS CHECK POWER ON AMR TRANSMITTER FCC INFORMATION Changes or modifications not expressly approved by Mueller Systems, LLC could void the user's authority to operate the equipment.