Users Manual

4.0.5 Activating an Alarm

sec

Long press the Down or Enter button. The alarm sounds.

NOTE: If the button(s) is released before the three-second

countdown ends, the alarm is not activated.

4.0.6 Cancelling an Alarm

Long press the Down or Enter button.

NOTE: If the button is released before the three-second countdown ends, the alarm does not turn off.

(1) Select YES in the the CANCEL ALARM dialog box. The alarm is cancelled.

4.0.7 Pairing with an External Device

Pairing can be established with external devices using the RFID tag in LUNAR.

24 MSA LUNAR

4 Basic Operation EN

PAGE 1
4 Basic Operation EN 4.0.5 Activating an Alarm Long press the Down or Enter button. The alarm sounds. NOTE: If the button(s) is released before the three-second countdown ends, the alarm is not activated. 3 sec * 4.0.6 Cancelling an Alarm Long press the Down or Enter button. NOTE: If the button is released before the three-second countdown ends, the alarm does not turn off. (1) Select YES in the the CANCEL ALARM dialog box. The alarm is cancelled. * 4.0.
PAGE 2
EN Successful ConnectionPairing 4.1 4 Basic Operation (1) Ensure the external device is in Data Link Mode, or Pairing Mode. (2) Touch the RFID tag on LUNAR to the external device. (3) Scroll through the TIC palettes until the Status screen is displayed. Connection Established and then LostNo Pairing Configuring and Maintaining 4.1.
PAGE 3
4 Basic Operation EN Connection in ProgressSuccessful Pairing (1) Select DONE. (2) In the DISCONNECT dialog box, select YES to disconnect or NO to remain paired. Not Actively Transferring DataNo Pairing 4.1.2 Updating Firmware Software If a firmware update is available, it can be installed from the Maintenance menu. This applies to LTE only. (1) 26 Open the Maintenance menu.
PAGE 4
EN 4 Basic Operation (2) Select UPDATE FIRMWARE. (3) Select YES to confirm the update. To cancel the update, select CANCEL. NOTE: To update the firmware, the battery level must be at 50% or higher. 4.1.