User's Manual

ManualsBrandsMS Sed ManualsElectronicsMOTION SENSOR

MicroStar blue Motion and Presence Sensor Installation Instructions

FCC Compliance

This device complies with part 15 of the FCC Rules Operation is subject to the following

two conditions: (1) This device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired

operation.

FCC Warning Statement

Changes or modifications not expressly approved by MS Sedco could void the user's

authority to operate the equipment.

Product Description

The microStar blue is the combination motion and presence sensor that provides superior

activation and safety for automatic sliding doors in a single device. The microStar blue

uses patented microwave technology to create two seamless zones within its detection

pattern. The activation zone provides selectable unidirectional or bidirectional motion

detection. The safety zone provides contiguous presence detection at the threshold and

through it when the door is open. The microStar blue’s proprietary software will learn the

movement of the door and then ignore it when opening and closing thus allowing the

safety zone to provide protection through the threshold area of the door. Two relay

outputs are standard. Relay output #1 is for the activation (motion) zone and Relay

output #2 is for the threshold safety (presence) zone.

Insert sensor component pictures here

Installation Preparation

Prior to installing this sensor verify you have the correct version microStar for the

type of door it is being installed on. Match the color-coded microStar logo on the

sensor cover to Chart A below.

(A) microStar Applications Chart

Sliding Folding Swinging Revolving

Doors Doors Doors Doors

microStar red X-safety

microStar white X-approach X-approach

microStar blue X-approach/safety

microStar green X-approach/safety

Warning w/symbol: Remember to follow these safety precautions:

Summary of content (4 pages)

PAGE 1
MicroStar blue Motion and Presence Sensor Installation Instructions FCC Compliance This device complies with part 15 of the FCC Rules Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Warning Statement Changes or modifications not expressly approved by MS Sedco could void the user's authority to operate the equipment.
PAGE 2
• • • • Shut off power to the automatic door before wiring sensor. Always ensure wiring is located clear of any moving door parts to avoid damage. Always be aware of pedestrian traffic. Keep people clear of the work area when setting up or testing the door. Comply with all applicable building codes and safety standards (ANSI A156.10). Sensor Mounting: 1. Remove the cover of the microStar by placing the blade of a small screwdriver in the notch in the right side of the cover as shown (B).
PAGE 3
(F) Main Circuit Board Diagram (with dip switches, adjustment pots, relays, antenna adjustments identified) (G) Dip Switch Settings Chart (Include drawing of dip switches) Dip Switch Positions: 0= Left; 1= Right Dip Default Switch Function Setting 1* Detection Direction 0=Bi-directional 1=Uni-directional 1 2 Motion Sensitivity 0=Less Sensitive 1=More Sensitive 1 3 Threshold Safety 0=OFF 1=ON 1 4 Fail Safe State 0=Enabled 1=Disabled 0 5** M-T-P** 0=OFF 1=ON 1 6* Direction 0=Depart Only 1=Approach Only 1 *Dip
PAGE 4
If the pattern needs any adjustment, the pattern size is adjusted via the Motion Range Pot. Pattern position to the door is adjusted by physically moving the antenna in or out (vertical tilt) and left to right (lateral tilt) as shown (F). Factory settings are ?˚ vertical tilt and 0˚lateral tilt. Notice w/symbol: The threshold safety (presence detection) will not operate at this point. Only the motion detection capabilities are functioning. 7. When desired pattern is achieved, remove power from the sensor.