User Manual

8701 Castle Park Drive n Indianapolis, Indiana 46256
Telephone: [phone] n www.mssedco.com n [e-mail]
Page 1
Section 1
General Description
Section 2
.
!
CP-TXHH
Universal 300/390 MHz Handheld Transmitter
The CP-TXHH radio transmitter is designed to provide reliable WIRELESS activation of any automatic door. It is part
of the most extensive line of programmable wireless products available.
The CP-TXHH radio transmitter is a universal unit which can operate in either the 300MHz or 390MHz systems.
The CP-TXHH transmitter is housed in a lightweight, ergonomic handheld enclosure. Two screws allow access for
easy battery replacement and programming/setup.
Basic Operation
1) Remove the cover of the handheld enclosure by removing the two screws on the back side of the unit.
2) Program the transmitter by setting the 12 dip switches on the printed circuit board (PCB) to match the receiver.
Only use the first 10 switches for the 300MHz system. Then, set the slide switch (SW2) to either 300MHz or
390MHz as shown below (fig. 1)
4) Pushbutton 1 will transmit the code on the dip switches, while pushbutton 2 will transmit the same code with
dip switch #2 in the opposite position.
3) Reassemble the unit into the enclosure and tighten the two screws.
CP-TX
CP-TXHH
Figure 1
WARNING: Any changes or modifications not expressly approved by MS Sedco could void the user’s authority to operate
this equipment
OPERATING INSTRUCTIONS
CP-TXHH PCB
390
300
SW2
TYPE A23
BATTERY
-
+
CP-TXHH ENCLOSURE