Integration Instructions

ManualsBrandsMrinq Technologies LLP ManualsElectronicsWireless Module



ModuleIntegrationInstructions

SPNYPAMOD-52832 is powerful, highly flexible, ultra-low power Bluetooth Low

Energy 4.2 (BLE 4.2) modules using Nordic nRF52832 SoCs. It was designed for high

data rate, short-range wireless communication in the 2.4GHz ISM band. With an ARM

CortexTM M4F MCU, available 512KB flash, 64KB RAM, embedded 2.4GHz multi-

protocol transceiver, power amplifier, and an integrated 2.4GHz Mini antenna or an

UFL connector for external antenna.

The SPNYPAMOD-52832 is a 16.5 mm × 23 mm module with antenna. It allows

developers to take full advantage of the nRF52832 by making all its I/O available via

36 SMD 1.1mm pitch pads.

Four GPIOs are used to control power amplifier. Other GPIOs of nRF52832 can be

accessed from main board.

MechanicalSpecification:

36SMDPackage



SIDE VIEW



TOP VIEW



Summary of content (4 pages)

PAGE 1
Module Integration Instructions SPNYPAMOD-52832 is powerful, highly flexible, ultra-low power Bluetooth Low Energy 4.2 (BLE 4.2) modules using Nordic nRF52832 SoCs. It was designed for high data rate, short-range wireless communication in the 2.4GHz ISM band. With an ARM CortexTM M4F MCU, available 512KB flash, 64KB RAM, embedded 2.4GHz multiprotocol transceiver, power amplifier, and an integrated 2.4GHz Mini antenna or an UFL connector for external antenna. The SPNYPAMOD-52832 is a 16.
PAGE 2
PCB Footprint and Dimensions: List of applicable FCC rules:         CFR 47 FCC Part 15, Subpart C, 15.203 CFR 47 FCC Part 15, Subpart C, 15.205 CFR 47 FCC Part 15, Subpart C, 15.207 CFR 47 FCC Part 15, Subpart C, 15.209 CFR 47 FCC Part 15, Subpart C, 15.247 CFR 47 FCC Part 2, 2.1051 CFR 47 FCC Part 2, 2.1053 CFR 47 FCC Part 2, 2.1091 Operational use conditions: Regulated power for the SPNYPAMOD-52832 is required. The input voltage Vcc range should be 1.7V to 3.6V.
PAGE 3
The Nordic Softdevice is required to use BLE application. There are many methods to flash the module. The official method from Nordic is to use nRFGo with J‐Link. It is available on windows operating system. Nordic Software: The Nordic SDK and software tools can be downloaded from http://developer.nordicsemi.com. Community support forum at https://devzone.nordicsemi.com.
PAGE 4
Additional testing: The OEM integrator is still responsible for the FCC compliance requirement of the end product, which integrates this module. Appropriate measurements (e.g. 15 B compliance, 15C intentional emissions (Fundamental + Out‐of‐Band Emission)) and if applicable additional equipment authorizations (e.g. Verification , DoC) of the host device to be addressed by the integrator/manufacturer.