Moxa 2.4/4.9/5 GHz WAPN008-1 User’s Manual www.moxa.com First Edition, May 2019 2019 Moxa Inc. All rights reserved. Reproduction without permission is prohibited.
WAPN008-1 User’s Manual The hardware and software described in this manual is furnished under a license agreement and may be used only in accordance with the terms of that agreement. Copyright Notice Copyright 2019 Moxa Inc. All rights reserved. Reproduction without permission is prohibited. Trademarks MOXA is a registered trademark of Moxa Inc. All other trademarks or registered marks in this manual belong to their respective manufacturers.
Table of Contents Chapter 1 Introduction Overview Specification Chapter 2 Getting Started Module Layout Block Diagram Hardware Installation Software Installation
WAPN008-1 User’s Manual Introduction 1 Chapter 1 The following topics are covered in this chapter: Overview Specifications Introduction
WAPN008-1 User’s Manual Introduction Overview WAPN008-1 PCI module is designed to provide wireless communication for Moxa industrial wireless products. It communicates via 2.4 GHz/4.9 GHz/5 GHz channels. The WAPN008-1 uses the AR9344 SoC Wireless chipset from Atheros. Specification Features Chipset security engine Connectors Power requirement Dimension Operating Temperature Storage Temperature: Operates in 2.4 and 5 GHz frequency bands.
2 Chapter 2 Getting Started This chapter covers the module layout, and block diagram, hardware installation of the WAPN008-1. Software installation is covered in the next chapter.
WAPN008-1 User’s Manual Module Layout Top and Bottom Block Diagram Below is a block diagram of the WAPN008-1.
WAPN008-1 User’s Manual Connector Locations Getting Started
WAPN008-1 User’s Manual Getting Started PCI Bus Connector PIN Assignments Function Connect to Pin Pin Function Connect to 3.3v 3.3v 1 2 GND GND 3.3v 3.3v 3 4 GND GND 3.3v 3.3v 5 6 ERXD3 PHY RGMII 3.3v 3.3v 7 8 ERXD2 PHY RGMII 3.3v 3.3v 9 10 ERXD1 PHY RGMII 3.3v 3.3v 11 12 ERXD0 PHY RGMII 3.3v 3.
WAPN008-1 User’s Manual Getting Started Hardware Installation The WAPN008-1 can be installed into all Moxa wireless system board series. Step for Installation 1. Install the WAPN008-1 PCI card on the system board. Apply pressure to both bus connectors and gently press the board onto the stack. The board should slide into the matching bus connectors. Do not attempt to force the board, as this can lead to bent/broken pins. 2. Screw on the WAPN008-1 PCI card. 3. Screw on the all the necessary chassis.
WAPN008-1 User’s Manual Getting Started Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
WAPN008-1 User’s Manual Getting Started Information for the OEMs and Integrators Any party of the installer who likes to use the module of 4.9GHz band shall fulfill licensing requirement (§90.1207). The installation to Aeronautical mobile operations are prohibited (§90.1205). The end product with an embedded WAPN008-1 module may also need to pass the FCC Part 15 unintentional emission testing requirements and be properly authorized per FCC Part 15.
WAPN008-1 User’s Manual Getting Started