MiiNePort W1 Series User’s Manual First Edition, March 2012 www.moxa.com/product © 2012 Moxa Inc. All rights reserved.
MiiNePort W1 Series User’s Manual The software described in this manual is furnished under a license agreement and may be used only in accordance with the terms of that agreement. Copyright Notice © 2012 Moxa Inc. All rights reserved. Trademarks The MOXA logo is a registered trademark of Moxa Inc. All other trademarks or registered marks in this manual belong to their respective manufacturers.
Table of Contents 1. Introduction ...................................................................................................................................... 1-1 Overview ........................................................................................................................................... 1-2 Product Features ................................................................................................................................ 1-2 Product Specifications ............
1 1. Introduction The MiiNePort W1 series provides serial to 802.11 b/g embedded wireless solution with compact size, and ultra low power consumption features. Numerous operation modes are designed to fulfill the requirements of embedded module application. Complete driver support reduces software redesign effort and accelerate time to market.
MiiNePort W1 Series Introduction Overview The MiiNePort W1 series is a very compact module that installs in a serial device to connect it to a wireless LAN. With such a small size, around half the size of a credit card., it can be installed into almost any kind of serial device. The MiiNePort W1 series also comes with a built-in TCP/IP stack for fast integration with your serial devices.
MiiNePort W1 Series Introduction Stop Bits: 1, 2 Parity: None, Even, Odd Flow Control: RTS/CTS, XON/XOFF Baudrate: 50 bps to 921.
2 2. Getting Started This chapter includes information about installing MiiNePort W1 series.
MiiNePort W1 Series Getting Started Dimensions MiiNePort W1 Series Dimensions Unit: mm (inch) 2-2
MiiNePort W1 Series Getting Started MiiNePort W1 Pin Assignments Pin JP3 JP4 JP6 JP7 1 N.C. 2 N.C. Eth_10M_LED PIO0 LTXD0 Eth_100M_LED PIO1 LRTS0 3 N.C. Eth_Rx+ PIO2 LDTR0 4 RDY_LED Eth_Rx- PIO3 LRXD0 5 FLT_LED Eth_center_tap PIO4 LCTS0 6 HW_RESET Eth_center_tap PIO5 LDSR0 7 SW_RESET Eth_Tx+ PIO6 LDCD0 8 WLAN_Link Eth_Tx- PIO7 N.C.
MiiNePort W1 Series Getting Started Wiring Requirements ATTENTION Before connecting the hardware, follow these important wiring safety precautions: Disconnect power source Do not install or wire this unit or any attached devices with the power connected. Disconnect the power before installation by removing the power cord before installing and/or wiring your unit. Follow maximum current ratings Calculate the maximum possible current in each power wire and common wire.
MiiNePort W1 Series Getting Started Hardware Installation Steps for Installation 1. Attach the WLAN antenna to connect MiiNePort W1 2. Let MiiNePort W1 Module connect todevice. Software Installation After physically installing the MiiNePort W1, the module must be recognized on the new system board by the following steps. Step for Installation 1. Apply power to the system board.
3 3.
MiiNePort W1 Series Compliance Notice Federal Communications Commission Statement WARNING This is a Class B product. In a domestic environment, this product may cause radio interference. The user may be required to take appropriate measures. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
MiiNePort W1 Series Compliance Notice Information for OEM and Integrators The following statement must be included with all versions of this document supplied to an OEM or integrator, but should not be distributed to the end user. 1. This device is intended for OEM integrators only. 2. Please see the full Grant of Equipment document for other restrictions.