GyroRemote and Mobile RF Keyboard User Guide
GyroRemote Always On Button Indicator Tools 1-4 LED Channel Button Teach Button Tools 5, 6 (not shown) Activation Trigger Right/Left Select Buttons Battery Compartment To Set Up and Synchronize the GyroRemote and the RadioLink Receiver: 1. Power on your computer and connect the RadioLink Receiver USB cable into an available USB port on your computer. 2. Follow standard USB device installation screens. 3. Insert 4 AAA batteries into GyroRemote handset.
To Change the Channel GyroRemote Is Using: When more than one RadioLink device is being used in the same proximity, each device should be set to operate on a unique channel. If more than one device is attempting to simultaneously operate on the same channel, the red “Conflict” LED on the RadioLink receiver will flicker and input control may be intermittent. To change the channel: 1. Press and hold the CHANNEL button on the GyroRemote handset for 2 seconds.
Installing or Replacing the Batteries GyroRemote operates on four standard or alkaline AAA batteries. When GyroRemote’s batteries reach 20% of a full charge the Status LED will blink when it normally lights solid. For instance, clicking and holding a button on a fully charged remote causes the Status LED to light solid. Clicking and holding a button on a remote with low batteries will cause the Status LED to blink intermittently. To replace the batteries: 1.
Gyration Mobile Keyboard Status LED Channel Button Teach Button To Set Up and Synchronize the Keyboard with the RadioLink Receiver: 1. Power on your computer and connect the RadioLink Receiver USB cable into an available USB port on your computer. 2. Follow standard USB device installation screens. 3. Insert 4 AAA batteries into Keyboard. 4. Press and hold the LEARN button on the RadioLink Receiver for 2 seconds. The STATUS light will blink slowly, indicating that the receiver is in “Learn Mode.
1. Click and hold the CHANNEL button on the RF Keyboard for 2 seconds. When you release the button, the keyboard will change to the next channel and the green LED will flash. The number of times the green LED flashes indicates the new channel the keyboard is using. If a Teach/Learn sequence has already been performed, it will not be necessary to re-synchronize the devices.
Gyration RadioLink Receiver Learn Button Conflict LED Status LED Keyboard Status LEDs Learn Button: Pressing the Learn Button for 2 seconds puts the receiver into “Learn Mode” allowing you to synchronize one or more devices with the receiver. After devices have been synchronized, pressing the Learn button again for 2 seconds takes the receiver out of Learn mode. If the receiver is not manually taken out of Learn Mode, it will automatically return to Normal Mode after five minutes.
GyroRemote Troubleshooting Tips Symptom Reason Solution GyroRemote LED comes on when activate button is pressed, but receiver is unresponsive Remote and Receiver not Synchronized Perform a Teach/Learn sequence as described above. (page XX) Cursor is visible but shows no movement Gyro not activated Squeeze the trigger, double-click trigger or press crescent shaped activation button on top of GyroRemote. Cursor movement is choppy or erratic Radio Interference 1. Change the device’s channel setting.
REGULATORY INFORMATION ATTENTION! THIS DEVICE EMITS RADIO FREQUENCIES AND HAS NOT BEEN CERTIFIED BY THE FAA FOR USE ONBOARD AIRCRAFT. DO NOT USE THIS DEVICE AT ANY TIME ONBOARD CIVIL AIRCRAFT. TO MINIMIZE THE POSSIBILITY OF INTERFERENCE, POWER DOWN GYROREMOTE TO ENSURE THAT GYROMOUSE REMAINS OFF DURING FLIGHT. FCC Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.