MD2209 INSTALLATION INSTRUCTION Für die Installationsanweisungen auf Deutsch, siehe Seite 10~11. Pour l'instruction en Français, veuillez vous reporter à la page 12~13. Para las instrucciones de la instalación en Español, favor vea la página 14~15. Per le Istruzioni in Italiano, vedi pagina 16~17.
Before getting started, let’s make sure this mount is perfect for you! MAX:100mm/4" 1 Is your TV VESA equal to/greater than 50x50mm/2x2" and equal to/less than 100x100mm/4x4"? Yes --- Perfect! MAX: 100mm/4" No --- This mount is NOT compatible. 2 Does your TV Yes --- Perfect! (including accessories) weigh less than 22 LBS (10 kg)? No --- This mount is NOT compatible. 0.5"(12.7mm) thick or above wooden board 3 Where can you install this mount? Min. 0.5"(12.
Parts and Hardware WARNING:This product contains small items that could be a choking hazard if swallowed. Before starting assembly, verify all parts are included and undamaged. NOTE: Not all hardware included will be used. Wall Plate Unit TV Screws Spacers M4x12mm M4x30mm M6x17mm 2.
1-2 Choose Configuration ③ ③ ② ② ① ① ② ③ ① ① 50mm x 50mm ② 75mm x 75mm ③ 100mm x 100mm ① ② ③ 1-4 Need Spacer? 1-3 Select TV Screws No, go to PAGE 4 Bracket M4 M5 Short Screw for detailed combination. Washer TV back M6 Yes, go to PAGE 4 Long Screw Bracket for detailed combination.
1-5 Attach TV Plate to TV Back No! Screw and washer Spacer(s), screw and washer Tips: If you need to combine M6(f) screw with 2.5mm spacer(h), you have to remove the inner circle.
Parts and Hardware Wooden Board Min. 0.5"(12.7mm) Wall Plate Lag Bolt M6x25mm x4 The TV plate is off center about 0.63"/16mm to the wall plate. Please consider this point, when positioning your TV on the wall. Bolt Head UP! 0.63"(16mm) TV plate center Level Wall plate center Wall Plate CAUTION: To avoid potential personal injury or property damage: All 4 lag bolts MUST BE firmly tightened to prevent unwanted movement of the wall plate assembly.
Before hanging TV, please conduct "wall plate installation integrity test" first.
4-1 Tilting angle adjustment (+5°/-15°)： Pull TV to your desired angle then fasten 2 tilting bolts with Allen key . Tilting bolts +5° -15° Tilting bolts 4-2 TV leveling adjustment (±3°): Loosen 2 leveling bolts on the rear of TV plate by maximum 1 turns, adjust to level, and retighten to secure.
Push your TV to the wall. Pull down the strap and lock the TV plate to the wall plate. Important ! Make sure to stow the TV and fully lock the mount in place before your RV moves.
Allen key storage: For easy adjustment, you might put the Allen key on the wall plate as illustration.
Vor der Installation bestätigen Sie bitte zuerst, ob diese Halterung für Ihr Fernsehapparat geeignet ist! MAX:100mm/4" 1Ist der Abstand der Montagelöcher von Ihrem Fernsehapparat zwischen 50x50mm/2x2" und 100x100mm/4x4"? Ja - Perfekt! MAX: 100mm/4" Nein - Diese Halterung ist nicht geeignet! 2 Wiegt Ihr Ja - Perfekt! Fernsehapparat (inkl.
Installationsanweisungen Warnung: Dieses Produkt enthält kleine Teile, die beim Verschlucken zur Erstickungsgefahr führen können. Bevor Sie mit der Installation beginnen, überprüfen Sie bitte, ob alle Zubehörteile und Ersatzteile vollständig und unbeschädigt sind. Hinweis: Es wird nicht das gesamte mitgelieferte Befestigungsmaterial verwendet.
Avant l'installation, veuillez assurer que ce support est adapté à votre téléviseur ou pas ! MAX:100mm/4" 1Est-ce que la distance entre des trous de montage de votre téléviseur est plus de ou égale à 50x50mm/2x2" et moins de ou égale à 100x100mm/4x4"? Oui - Parfait ! MAX: 100mm/4" Non - Ce support ne vous convient pas ! 2 Est-ce que votre téléviseur et des autres accessoires pèsent totalement moins de 10 kg (22LBS) ? Oui - Parfait ! Non - Ce support ne vous convient pas ! Les planches de 12,7mm (0,5
Instruction d'installation AVERTISSEMENT : Ce produit contient des petites pièces, en cas d'ingestion, des risques de suffocation y arrivera. Avant l'installation, veuillez vérifier que tous les accessoires et toutes les pièces sont complets et non défectueux. ATTENTION : Les pièces fournies ne seront pas toutes utilisées durant l'installation.
Antes de comenzar a instalar este soporte mural para tv , favor confirme si es el adecuado para su televisor! MAX:100mm/4" 1Los orificios posteriores de su televisor tienen una distancia mayor o igual a 50x50mm/2x2" y menor o igual a 100x100mm/4x4"? Si - Es el adecuado! MAX: 100mm/4" No - Este soporte no es el adecuado! 2 El peso de su Si - Es el adecuado! televisor y los demás accesorios en total es menor a 10 kg (22LBS) ? No - Este soporte no es el adecuado! Pared de madera de 12,7mm (0,5”) de g
Instrucciones paso a paso de su instalación Advertencia: Este producto contiene piezas pequeñas, si por error se ingiere, puede provocar peligro de asfixia. Antes de comenzar la instalación, favor compruebe que todos los accesorios y piezas de repuesto estén completas y sin daño alguno. Atención: No todas las piezas se utilizarán. Paso 1 Instalar la placa de TV al televisor Ver página 2 Consejos: si tiene que combinar un tornillo Accesorios y piezas M6 (f) con un espaciador de 2.
Prima di iniziare l'installazione, per prima cosa conferma se questo Supporto è ideale per la vostra TV! MAX:100mm/4" 1La distanza dei fori di installazione TV sono superiore/uguale a 50x50mm/2x2" e inferiore /uguale a 100x100mm/4x4"? Sì - Ideale! MAX: 100mm/4" No - Questo supporto non va! 2 Il tuo televisore Sì - Ideale! (inclusi accessori) pesa totalmente inferiore a 10 kg (22 LBS) ? No - Questo supporto non va! Piastra in legno spessa 12,7mm (0,5") o superiore 3 Dove puoi installare questo sup
Istruzioni di installazione Avvertenza: Questo prodotto contiene piccoli articoli che potrebbe causare il pericolo di soffocamento se ingoiati. Prima di iniziare l'installazione, controlla se tutti gli accessori e parti siano inclusi e non danneggiati. Nota: Non verranno utilizzati tutte le parti incluse.
