Introduction Congratulations on your purchase of the Motorola homesight™ Wireless Day/Night Camera. A high-resolution color video camera, it includes a built-in heat/motion detector and an audio microphone. These features enable you to secure an area, rain or shine, day or night. This Quick Start Guide describes how to set up and troubleshoot your Wireless Motion Sensor Camera.
Installation Overview Installing your camera is a simple process. 1 Choose an appropriate location for the Wireless Motion Sensor Camera as described in the Installation Hints. 2 Plug the AC adapter into the wall and the module. 3 Register your camera with your Wireless System Controller using a process called Discovery. Refer to your Wireless System Controller documentation for instructions on how to discover your Wireless Motion Sensor Camera.
Installing Your Camera Your camera can either be mounted on a wall or just sit on a level surface. Wall Mount Your Wireless Camera Make sure the power adapter cord is long enough to reach your mounting location. Also, be sure the AC outlet cannot be switched on and off with a wall switch. Warning: When mounting near a window, drilling too close to the glass could break the glass and possibly cause it to shatter.
Wall Mount Drilling Template Mounting tools: Screwdriver, electric drill or awl. On hard surfaces, Motorola recommends that you pre-drill ½-inch deep pilot holes with a drill bit slightly smaller than the camera mounting screws before securing the camera to the surface. When mounting a camera on soft surfaces like sheetrock, use an awl to punch holes in the material slightly smaller than the plastic anchors included in the hardware mounting kit.
Troubleshooting Problem Camera will not register with the Wireless System Controller Solution • Ensure that the camera is powered and the power switch is On (table mount base). • Ensure that the Wireless System Controller is powered and online. • Ensure that you are pressing the Discovery button. • Reposition the camera closer to the Wireless System Controller. • Try a hard reset by holding down the Discovery button while powering up the camera.
Features and Specifications • Device signal communication • Red LED behind motion detector lens illuminates when activity occurs • Microphone captures audio • 60 degree field of view for motion and camera lens • Auto brightness, auto contrast, auto white-balance • All hardware for either wall or tabletop mounting included • AC operation Integrated lens: 4.3 mm, F1.
Regulatory Information CAUTION: Changes or modifications not expressly approved by Motorola for compliance could void the user’s authority to operate the equipment. FCC Compliance Class B Digital Device This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential environment.
Limited Warranty Wireless Motion Sensor Day/Night Camera Motorola, Inc., Connected Home Solutions (" Motorola") Limited Warranty.
Visit our website at: http://www.motorola.com/homemonitoring Copyright © 2005 by Motorola, Inc. All rights reserved. No part of this publication may be reproduced in any form or by any means or used to make any derivative work (such as translation, transformation or adaptation) without written permission from Motorola, Inc.