Skiing is better with friends ...and so is Carv www.getcarv.com/carv-with-friends Let your friends know about Carv so you can get the most from your trip this year.
Let’s get Carving User manual Contents Introduction 3 What’s in the box 4 Installation guide 5 Ski boot installation Connecting and setting up sensors 6 12 Regulatory information 14 Warranty 16 FAQs 17 1
Take your skiing to the next level Introduction Hello and welcome to Carv. We believe that everyone, no matter how good or experienced you are, wants to get better. If we can help you improve and give you that magical feeling of learning a new skill, then we have achieved our goal. And hopefully in the process, we’ll also increase your love, enjoyment and respect for the mountains. When you see a QR code like this one, you can scan it and open the link with your smartphone’s camera app.
Bits and pieces What’s in the box First things first Installation guide x2 Inserts x2 Trackers x2 Charging cables To get started you’ll need your Carv device, mobile phone and ski boots to hand. First, download the Carv app and get signed up. x6 Cable secure tape 4 x6 Sticky tabs If you don’t have your ski boots with you, just skip the ski boot installation for now and start by exploring the app.
Installation video Step 1 - Plug-in and charge the trackers Step 2 - Remove ski boot liners Step 3 - Clean We recommend you go to the link shown above to watch our step-by-step guided installation video. When charging, the Carv logo on each tracker lights up to indicate the following: Make sure the buckles and power strap are open. Clean the area where the heel is positioned in the boot - we’ll be sticking the Carv inserts down here so it’s important the area is free from dirt.
UNDER SIDE AVOID OVER-BENDING Step 4 - Attach sticky tabs Step 5 - Place inserts in boot Step 6 - Secure cables Step 7 - Replace ski boot liner Get the sticky tabs from the set-up box and then remove one side of the semi-transparent backing and attach to the underneath heel of the Carv Inserts. Now remove the remaining backing from the tab so that the sticky side is exposed. Ensure a centred position and then apply pressure at the heel to fix in place.
Step 8 - Attach trackers to boot Step 9 - Connect tracker Step 10 - Grab your phone! To complete set-up, unplug your trackers from the charging cables and attach the trackers to your power strap on the outside of your boot, squeezing the clip until it clicks and the tracker is held firmly in place. Plug the insert cables into the trackers. The trackers should quickly flash green. If they don’t, try charging them or contact us on support getcarv.com/support.
Grab your phone Connecting and setting up sensors Step 1 - Open the sensor setup page Step 3 - Calibrate motion Step 4 - Calibrate force When you open the Carv app for the first time you will be prompted to start the sensor setup process. Click ‘Carv setup’ to begin. You’ll be able to access this from the Activity screen or later on from the More section. Because of the metal in your boots, the magnetometer sensor (a bit like a digital compass) needs to be calibrated before you ski.
The boring stuff United States Regulatory information This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference received, including interference that may cause undesired operation. Caution: This marking indicates that the user should read all included documentation before use. Retain this supplement for future reference.
We’ve got you covered Want to know more? Warranty information Frequently asked questions We offer everyone 2 years warranty. Head to our FAQs page where we’ve got loads more information: See full warranty details at: getcarv.com/support getcarv.