User's Manual

Table Of Contents

Moticam S2

Assembly

Thank you for purchasing our Moticam S2 solution.

This quick step guide will show you how to place the Moticam S2 onto

a C-mount microscope.

Note:

Please note that the Moticam S2 is a C-mount camera, therefore you

must have a trinocular microscope with a relevant C-Mount adapter

between 0.5X and 0.65X magnification.

Step 1: Unscrew the protective dust cover from the

bottom of the Moticam S2 to expose the imaging

sensor to light.

Protective

dust cover

Moticam S2

C-Mount adapter

Trinocular Microscope

PAGE 1
Moticam S2 Assembly Thank you for purchasing our Moticam S2 solution. This quick step guide will show you how to place the Moticam S2 onto a C-mount microscope. Moticam S2 C-Mount adapter Trinocular Microscope Note: Please note that the Moticam S2 is a C-mount camera, therefore you must have a trinocular microscope with a relevant C-Mount adapter between 0.5X and 0.65X magnification.
PAGE 2
Step 2: Mount the Moticam S2 onto your microscope’s C-mount, and if your microscope is equipped with a beam splitter, pull the beam splitter to ensure light can reach to the trinocular port. Power button Step 3: Plug in the Moticam S2 power supply and press the power button to start. Step 4: Press and hold the power button for 2-3 seconds to boot up the Moticam S2. Step 5: Select the MotiConnect T software from the tablet home screen, and the software is ready to take your first images.
PAGE 3
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications or changes to this equipment. Such modifications or changes could void the user’s authority to operate the equipment.