User's Manual

RF keyboard/K9300G

Operation procedure

1.Insert two AAA batteries to the RF Keyboard , and close the battery cover.

2.Plug in the Receiver to the USB port of P.C.

3.Press the Connect button of RF Keyboard for pairing with the Receiver within

30Sec.

4.Access LED will go off and RF Keyboard is ready. If Access LED is still

blinking, please repeat the above procedure 1 to 3 again.

PAGE 1
RF keyboard/K9300G Operation procedure 1.Insert two AAA batteries to the RF Keyboard , and close the battery cover. 2.Plug in the Receiver to the USB port of P.C. 3.Press the Connect button of RF Keyboard for pairing with the Receiver within 30Sec. 4.Access LED will go off and RF Keyboard is ready. If Access LED is still blinking, please repeat the above procedure 1 to 3 again.
PAGE 2
Federal Communication Commission Interference Statement THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules.