Owner’s Guide and Installation Manual C H I C A GO,IL WATTS: 40 W 3CPR60XXX Series Fan cETL Model NO. : 3CPR60XXX Attach sales receipt to this card and retain as your proof of purchase DATE OF PURCHASE: RETAILER NAME: MODEL NUMBER: RETAILER ADDRESS: To register your fixture, please visit our website www.montecarlofans.com 7 kg 15.
Cautions and Warnings WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING READ AND SAVE THESE INSTRUCTIONS Installation work and electrical wiring must be done by qualified person(s) in accordance with applicable codes and standards (ANSI/NFPA 70), including fire-rated construction. Use this unit only in the manner intended by the manufacturer. If you have any questions contact the manufacturer.
1 2 ON 3 ON Mounting bracket OFF OFF Before you begin installing the fan, Switch power off at Service panel and lock service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a warning device, such as a tag, to the service panel. Use AC 120V/60HZ power supply only. 4 Before installing this fan make sure the outlet box is properly installed to the house structure.
7 8 SAFETY CABLE INSTALLATION 9 Pin Tab Canopy Decorative cap Lag screw Safety cable Slot Washer Lock washer Place decorative cap and canopy over lead wires, safety cable and downrod, and then replace the hanger ball. Replace the hanger ball with pin and set screw and tighten securely. Warning: Make sure the pin is installed well on hanger ball with downrod. Note: If the fan to be installed on a slope ceiling, the decorative cap shouldn’t be installed corresponding to next installation step.
13 14 15 This side up Top plate Adapter Long set screw Short set screw C H I C A GO,IL WATTS: 40 W Blade Blade bracket Install blade onto blade bracket with a top plate by 4 blade screws provided. Tighten screws securely. Repeat this process for remaining blades. Note: Make sure the side with a mark “This side up” is installed upward. © 2020 Monte Carlo Fan Collections Firmly insert a blade bracket with blade into the adapter.
Remote Controller Operation Remove the battery cover from the remote control transmitter and install batteries. Replace the cover. This remote uses 2 1.5V/AAA batteries.
Install Transmitter wall mount cradle with 2 screws provided. The receiver provides the following protective functions Lock protection- The DC motor has a build-in safety feature against blade obstruction during operation. If something obstructs the fan blades, the motor will stop operation after about 20 seconds of interruption. Please remove obstacles and reset it by turning the power off, and turn it back.
Trouble Shooting or wiring. In some cases, these installation errors may be mistaken for defects. If you experience any faults, installation, please call our Customer Service Center at the number printed on your parts list insert sheet. Warning means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel. Trouble 1. If fan does not start: Suggested Remedy 1.
Jan.