Instructions / Assembly
Assembly Instructions for Console Table with Shelf
Thank you very much for purchasing an heirloom quality console table from Montana Woodworks®.
Should you have any questions or need to contact sales or support, please do not hesitate to contact the
customer service representatives at our corporate offices at 1.888.889.3728 or via E-Mail at:
cs@montanawoodworks.com
Before beginning assembly please take a few moments to read the instructions carefully, understanding
each step before beginning.
Tools Needed: 9/16 Wrench or Socket, Phillips # 2 Screw Driver or Square Drive Bit/Driver
Parts List: ( 4 ) 3/8 Diameter x 4 Inch Long Lag Screws, ( 4 ) Screws
Component List: ( 1 ) Console Cabinet, ( 1 ) Lower Shelf, ( 2 ) Leg Assemblies
.
Step 1. Lay cabinet assembly upside down on a safe, non-marring surface.
Step 2. Position leg assembly so that portion with pre-drilled holes are turned inward toward cabinet corners.
Step 3. Align pre-drilled holes in leg assembly with cabinet corners.
Step 3. Insert one 4 inch lag into the cabinet corner interior support and tighten until leg assembly is snug against cabinet.
CAUTION: Do not over tighten lag bolts!
Step 4. Repeat step 3 above, for second lag bolt on same leg assembly.
Step 5. Repeat steps 3 and 4 for other leg assembly.
Step 6. Carefully lay the cabinet and leg assembly on its back being cautious to support leg assemblies during the move.
Step 7. Center lower shelf between leg assemblies and tighten pre-started screws in the leg cross supports until the
shelf is snug against cross supports.
ASSEMBLY IS NOW COMPLETE
*Please Note: If you purchased your console cabinet “ready to finish”, special care must be taken to properly apply a high
grade final finish in a timely manner. Doing so will help protect your purchase from discoloration and damage cause by
exposure for ultra violet light.
PROUDLY MADE IN THE U.S.A.