Assembly Instruction
MONTANA WOODWORKS, INC.
ASSEMBLY INSTRUCTIONS FOR FUTON FRAME & FUTON FRAME W/ MATRESS
Thank you very much for purchasing our heirloom quality futon. Should you have any quesons or need to contact sales or support,
please do not hesitate to contact our corporate oces at 888.889.3728 or via E-Mail at: cs@montanawoodworks.com
Before beginning assembly please take a few moments to read the instrucons carefully, understanding each step. Likewise, please
also ensure that the hardware package contains the items as described here.
Tools Needed: ½” wrench, 9/16” wrench
Parts List: (2) 74” Cross Rails (2) Arm Rest Panels (1) Seat Frame (1) Back Frame
(2) Hinge Brackets
Hardware List: ( 4 ) 3” Lag Bolts ( 8 ) 4” x 5/16” diameter carriage bolts ( 8 ) 5/16” Flat Washers
( 8 ) 5/16” Nuts
Steps: 1. Set arm rest panels on oor with hinge brackets facing each other.
2. Insert 74” cross rails, at side up, between armrest panels into 2” holes.
3. Secure 74” cross rails using 3” lag bolts. ( Do not ghten completely; this will be done in step 5)
4. Aach seat and back frames by: (Both the seat and back frame are idencal)
a. Insert 4” carriage bolts into pre-drilled holes in seat and back frames.
b. Place seat on hinge bracket, lining up carriage bolts with holes in hinge bracket.
c. Place washer and nut onto carriage bolt and nger ghten.
d. Repeat steps 4.a. through 4.c. for back frame.
5. Once all parts are installed and aligned, ghten lag bolts and carriage bolts using wrenches.
6. Lay futon frame at by liing up seat and pulling outward. Back frame will recline and you can lay seat
frame fully down.
7. Place futon maress, if so equipped, onto back and seat frames. Maress is idencal; either end will
work just ne for seat or back cushion and can be rotated or ipped as necessary to avoid uneven wear.
Enjoy your new futon; it is now fully assembled.
Montana Woodworks recommends that you purchase a futon cover to protect your new futon maress.