Confidential Preliminary – Subject to Change User manual For the Traxit 3 2G GPS Tracker Model Name:TXL1G2-3 By Montage Asia November 28, 2012 Revision History Revision X1.00 Date 11/28/12 Description Initial Release 2012 China Mark, Ltd.
Confidential Preliminary – Subject to Change Scope This document is a user manual for the TXL1G2-3 tracking device. Description The TXL1G2-3 Tracker is a self contained, expandable, integrated commercial grade vehicle tracking device that uses GPS satellite location in combination with a quad band (Optional:850MHz & 1900MHz or 900MHz & 1800MHz) GSM/GPRS cellular radio connection to report that location. TXL1G2-3 is optimized for reliability, cost and size.
Confidential Preliminary – Subject to Change Over The Air (OTA) application firmware updates are supported through at TFTP connection to a server. The entire image can be updated using one simple command. All inputs are electrically hardened against overvoltage and over current conditions present in automotive environments. This includes transient electrical noise and Electro Static Discharge (ESD). The power input is further protected against over current with an internal, self resetting fuse.
Confidential Preliminary – Subject to Change Figure 3 TXL1G2-3 Physical Attributes Sidecar Mounts Top Front LED Indicators AES/PC Plastic Enclosure Main Connector Bottom Back M2 Fasteners (4 PL) M2 Fastener Expansion Door Top Back SIM Units: Inches [mm] 2012 China Mark, Ltd.
Confidential Preliminary – Subject to Change Interfaces There are one connectors on the TXL1G2-3.The connector provides electrically hardened signals interfaces for I/O and power. It is intended that this connector attach or be spliced into the cable harness of a vehicle. Signals Interconnects are oriented as shown in Figure 4 looking into the front of the port. Electrical properties are in the subsequent table. The connector is keyed and latched. Figure 4 Main Connector Pin 1 2012 China Mark, Ltd.
Confidential Preliminary – Subject to Change Main Signals Pin Number Name Description Properties 1 RLY Relay drive, connect relay coil between pin 6 and this pin Configurable as general input or output Configurable as general input or output 500mA, 16V tolerance open drain MOSFEET, TVS overvoltage protected 2.8V logic level, 16V tolerance, equivalent circuit in NOTE 2.
Confidential Preliminary – Subject to Change CE Regulations: Caution Risk of explosion if battery replaced aced by an incorrect type. Dispose of used batteries according to the instructions. Please make sure the temperature for device will not be higher than 55˚C The device is tested for typical body worn operation. The minimum distance between the user and/or any bystander and the radiating structure of the transmitter is 20cm.
Confidential Preliminary – Subject to Change FCC Regulations: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Confidential Preliminary – Subject to Change • Réorientez ou relocalisez l'antenne de réception. • Augmentez la séparation entre l'équipement et le receveur. • Connectez l'équipement à une prise sur un circuit différent de celui auquel de le receveur est connecté. • Consultez le vendeur ou un technicien radio/de télévision pour obtenir de l'aide. La FCC ou Industrie Canada peut vous obliger à arrêter d'utiliser votre appareil si une telle interférence ne peut pas être éliminée.
