User Instructions

Bluetooth® Pairing Instructions:

This Bluetooth keyboard can be paired with up to three devices at the same

time. The three pairings are saved to Q (default), W, and E. Quickly switch

between pairings by holding down the FN key and pressing Q, W, or E.

Perform the following steps to pair this keyboard with your device(s).

1. Set switch on the back of the keyboard to the ON position.

2. Press and hold the FN and Q + W + E keys for 3-5 seconds. When R starts flashing, the

keyboard is ready to connect.

3. Open the Bluetooth settings on your device and scan for available devices.

Locate and select the "Collider 60" entry.

4. Once the keyboard has connected to your device, the R key will cease

flashing, indicating that Bluetooth pairing was successful.

RGB Backlighting and Animations:

FN+I = Static ,Single-on, Single-off. Rotate, Scroll ,Roll

FN+O = Fall, Colorful, Glitter, Ripples, Explode, Launch

FN+P = Breath, Outward, Spectrum, Pulsate, Flow, Tilt

FN+>.= Increase backlight brightness

FN+<,= Decrease backlight brightness

FN+[{= Increase backlight speed

FN+]} = Decrease backlight speed

FN+;:= Switch dynamic backlight direction

FN+'"= Switch color of the backlight

Fn + Z/X/C=Backlight Macro recording key

Battery Charging:

• Battery Life: Bluetooth - 8 hours. Standby - 3 months.

• LED Indicator: Solid Red - Charging, Off - Fully Charged.

• FN key will blink repeatedly when the keyboard is low on battery.

• After 5 minutes without a keypress the backlighting will turn off to conserve

battery. After 30 minutes, the keyboard will enter standby mode and

disconnect from Bluetooth. Any keypress will reconnect the keyboard.

Custom Backlighting Mode Instructions:

1. Press FN+Z/X/C (Each key can store a custom backlight mode).

2. Press FN+Tab - (The LED will flash blue repeatedly to indicate recording).

3. Press the keys that you wish to set the backlighting for.

PAGE 1
Bluetooth® Pairing Instructions: This Bluetooth keyboard can be paired with up to three devices at the same time. The three pairings are saved to Q (default), W, and E. Quickly switch between pairings by holding down the FN key and pressing Q, W, or E. Perform the following steps to pair this keyboard with your device(s). 1. Set switch on the back of the keyboard to the ON position. 2. Press and hold the FN and Q + W + E keys for 3-5 seconds. When R starts flashing, the keyboard is ready to connect. 3.
PAGE 2
4. Press FN+Tab to exit the custom backlighting mode. Hot Keys: FN+WIN: Gaming Mode (Lock Windows® Key) FN+Backspace: Hold for 3 seconds to reset the Keyboard to factory defaults FN+Q/W/E: Switch between Bluetooth Profiles FN+Z/X/C: Swicth between custom backlighting profiles FN+Tab: Entering/Exiting Custom Backlighting Mode FCC STATEMENTS: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two co nditions: (1) This device may not cause harmful interference.