Specification Sheet

Dimensions and Specifications (in inches)
• The dishwasher must be installed so that the drain hose
is no more than 10 feet in length for proper drainage.
• Water and power supply should enter in the
shaded area.
• Electrical and water connections are at the right front
of the dishwasher. The hot water line should extend
forward 30" to 40" from the rear wall. The electrical must
extend forward at least 24" to reach the junction box.
• To prevent siphoning, an air gap must be used when
the waste tee or disposer connection is less than 18"
above the floor.
23-1/4"
MAX.
33-3/8" MIN.
adj to
34-5/8" MAX.
23-3/4"
29-7/8"
27-1/2"
4"(toekick)
Includes 3/4" custom panel
Electrical Requirements
The dishwasher must be supplied with 120V, 60Hz, and
connected to an individual properly grounded branch
circuit protected by a 15- or 20-amp circuit breaker or
time-delay fuse.
Custom Panel for Model ZDT800SIF
These dishwashers require a field installed 3/4” thick
custom panel and custom handle. An installation template
is packed with these models and may be obtained in
advance. Complete panel installation instructions are
included on the template.
CUSTOM PANEL SIZE REQUIREMENTS
HEIGHT
Panel height must
be between
30-1/16" and 30-1/4".
• If the panel height is
more than 30-1/4” it
will prevent the door
from swinging open.
• If the panel height is
less than 30-1/16” it
will not cover the
dishwasher door
frame.
• The top of the custom
panel must be flush with the top of the door. The 1/2”
minimum gap between the top of the door and the
bottom of the countertop must
be maintained.
WIDTH
Panel width must be 23-3/4".
• If the panel width is less than
23-3/4” it will not cover the
dishwasher frame.
IMPORTANT: To ensure
optimum door balance performance, the custom panel
must not weigh
more than 14 lbs.
Before installing refer to installation instructions for
details.
Minimum 1/2" Gap
for Clearance
Countertop
1/2" min.
23-3/4"
30-1/16" Min.
30-1/4" Max.
Minimum 1/2" Gap
for Clearance
Countertop
1/2" min.
23-3/4"
30-1/16" Min.
30-1/4" Max.
For answers to your Monogram,
®
Profile Series
or GE appliance questions, visit our website at
geappliances.com or call GE Answer Center
®
service, 800.626.2000.
As an ENERGY STAR
®
partner, GE has determined
that this product meets the
ENERGY STAR guidelines
for energy efficiency.
Listed by
Underwriters
Laboratories
* Dishwasher models
ZDT800SIF and ZDT870SIF
require a 3/4" thick
custom panel and will be
24-3/4" deep.
Specification Revised 11/13
150061
ZDT800SIFII/ZDT800SPFSS/ZDT800SSFSS
GE Monogram
®
Fully Integrated Dishwashers